Bissell 6583 warranty Cleaning post-motor filter, Check rotating floor brush and drive belt

Maintenance and care

Cleaning post-motor filter

Use only BISSELL Style 10 replacement filters in your BISSELL PowerForce Bagless.

1.	Unplug the cleaner from electrical outlet.
2.	The post-motor filter assists in the filtration
	process to return clean air to the room. It is
	located behind the door on the front of the	Post-Motor Filter
	cleaner. When the filter becomes dirty, open

the door, remove the filter and clean.

3.The post-motor filter may be hand washed in warm water. Mild detergent may be used if desired. Rinse well, then air dry thoroughly

	before replacing.	WARNING:
4.	Replace the door by inserting the tabs on the left
		To reduce the risk of
	side and snapping the right side into place.
		injury from moving parts,
Check rotating floor brush and drive belt		turn off vacuum cleaner
		and disconnect Power
You should check your vacuum cleaner’s rotating		Plug from electrical outlet.
floor brush and drive belt regularly for wear or
damage. You should also clean the brush and brush
ends of string, hair, and carpet fibers. These can wrap
around the brush and hamper its ability to effectively
clean your carpet. Also, remove any debris that has
accumulated under the brush cover.
1.	Unplug cleaner from electrical outlet.

2.Place handle in low position and turn vacuum cleaner over so bottom side is up.

3.Remove the four screws as shown with a Phillips head screwdriver. Lift the brush cover off.

Brush

Cover

4.Grasp rotating floor brush at both ends and lift.

5.Clean strings, hair and other debris from rotating floor brush, paying particular attention to brush ends.

6.Clean strings, hair and other debris from motor pulley and drive belt areas.

7.Check drive belt carefully for wear, cuts or stressed areas. Replace if worn.

8.Check air passageway for obstructions. Remove debris from this area.

Motor

Pulley

Air Passageway

10 w w w . b i s s e l l . c a

1 - 8 0 0 - 2 6 3 - 2 5 3 5