Maintenance and care
Power cord storage
When you have finished using your Easy Vac, store the power cord on the cord wrap.
1.Turn off vacuum cleaner and unplug power cord.
2.Loop power cord around cord wraps on back of cleaner, making certain Quick Release cord wrap is pointed up towards handle.
3.Clip molded plug to power cord to secure.
Clean and replace rotating floor brush
You should check your cleaner’s rotating floor brush and drive belt regularly for wear or damage. You should also clean the brush and brush ends by removing string, hair and carpet fibers. These can wrap around the brush and hamper its ability to effectively clean your carpet. Also, remove any debris that has accumulated under the brush cover.
1.Turn off vacuum and unplug from electrical outlet.
2.Place vacuum upside down with brush roll facing upwards.
3.Remove five screws as shown with a small Phillips screwdriver.
4.Lift off brush cover.
5.Grasp floor brush at both ends and lift out.
6.Clean strings, hair and other debris from floor brush, motor shaft, and drive belt.
7.Check floor brush for worn areas and replace if needed.
8.Check air passageway for obstructions. Remove debris from this area.
9.When finished cleaning, reposition floor brush and drive belt. Then replace the brush cover and five screws.
w w w . b i s s e l l . c o m
WARNING:
To reduce the risk of injury from moving parts and/or electrical shock, turn power switch OFF and disconnect polarized plug from electrical outlet before performing troubleshooting checks.
3.4.
Five Screws
5.8.
Air Passageway
9.
8 0 0 . 2 3 7 . 7 6 9 1 | 11 |
5/22/07 | 5:07:39 PM |