Note: It is recommended the tube be cleaned on a bare floor, or with some newspaper to cover the floor, to catch any loose material or dust removed during cleaning.
Release Bag Tension Spring.
Unplug Connector Plug.
Locate the Tube Release Button at the top of the Powerfoot. The button is hidden under a rubber collar. The button can be pressed through the rubber collar to release the tube. Lift off the tube while pressing on the rubber collar.
Replacement Bag: BISSELL® Style 6 Filtrete™ HEPA Bags (#32052, package of 3).
Cleaning the Dust Tube
The ProLite® features a wide diameter Dust Tube designed to optimize cleaning power. For best performance it should be routinely checked and cleared of excess dust and other debris.
Push Collar Retainer back into position and secure in place.
3.
4.
Tuck the remainder of the Dust Bag completely inside
5. the cloth Bag. Make sure it lays flat, top to bottom, without bunching. Zip cloth Dust Bag.
Slide collar of new Dust Bag completely into Collar Retainer.
Routine Maintenance
For maximum performance from your BISSELL® ProLite® Lightweight Upright vacuum cleaner, it is recommended you perform these simple maintenance checks.
Replacing the Dust Bag
The Dust Bag should be checked weekly. It should be replaced when it is near full or when cleaning suction diminishes. Never reuse a Vacuum Bag.
1. Unplug vacuum.
Unzip cloth Bag. Remove Collar Retainer by pressing on
2. the two tabs and then pull the top towards you. Slide Dust Bag collar up and out of retainer. Dispose of Dust Bag.
WARNING: To
reduce the risk of electric shock, turn Power Switch OFF and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting checks.
1.
2.
3.
Use a wire brush to clean out the inside of the tube and
4. the top section of the Powerfoot where the tube connects.
8
Tip:
Vacuum new car- pet or vacuuming fine powders may clog the Dust Bag. So check the bag more often
| Clean |
Tube | Rubber |
Release | Collar |
Button |
|
Tube
Release
Button