Troubleshooting, Reduced Spray or No Spray

Troubleshooting

Reduced Spray OR No Spray

Possible cause

1.Bladder may be empty

WARNING:

To reduce the risk of fire, electric shock or injury, unplug from the outlet before servicing.

Remedies

1.Turn power switch OFF; Refill bladder with clean hot tap water.

2.2-in-1 tank may not be seated properly.

3.Pump may have lost prime.

4.The pump belt may be broken.

Slots Pump Belt

DirtLifter PowerBrush Does Not Turn

Possible cause

1.The brush belt or pump belt is off or broken.

2.Turn power switch OFF; remove tank and reseat tanks.

3.Turn power switch OFF; after 1 minute turn ON and depress spray release trigger.

4.Turn power switch OFF and unplug from the outlet. To check if a pump belt has broken, you will need a flat head screwdriver.

A.Insert the blade end into the slot of the belt access door to release. Examine the belt for breakage. You should be able to see the pump belt looped around the motor shaft. If it is broken or missing, please refer to Replacement Parts on page 14.

Areplacement belt may be ordered at www.bissell.com or by calling BISSELL Consumer Services at 800-237-7691. Complete installation instructions

will accompany the replacement belt.

B.When replacing belt access door be sure to line up slots of belt access door with slots in machine, slide door into place and snap shut.

Remedies

1.Refer to Remedy 4 above to check if brush belt or pump belt is broken.

Cleaner Not Picking Up Solution

Possible cause

1.Removable nozzle may not be properly attached.

2.2-in-1 tank lid is not properly installed.

3.2-in-1 tank is not properly seated.

4.2-in-1 tank has picked up maximum dirty water.

5.The lint screen may be clogged

Remedies

1.Make sure nozzle is on correctly by slightly raising front of machine to line up slots on the base of the machine with the hooks on nozzle. Attach at base first and then click nozzle into place.

2.Re-install lid; refer to the image on page 8.

3.2-in-1 tank must be firmly seated to function; remove and reseat 2-in-1 tank.

4.Empty 2-in-1 tank and refill, refer to the Operation section.

5.Clean out lint screen. Refer to page 9.

Other maintenance or service not included in the manual should be performed by an

authorized service representative.

Thank you for selecting a BISSELL product.

Please do not return this product to the store

For any questions or concerns,BISSELL is happy to be of service.Contact us directly at 1-800-237-7691.

w w w . b i s s e l l . c o m

8 0 0 . 2 3 7 . 7 6 9 1

ug120-4073_1623_908.indd 13

10/14/08 12:59:41 PM