Make sure that the dust collector extension (1) is pushed back into the dust collector (2).
Make sure that the appliance is switched off. The battery will not be charged with the on/off switch (4) in the on position.
Place the appliance on the charging base (7) as shown.
Plug in the charger. Switch on at the mains.
The charging indicator (5) will be lit.
Leave the appliance to charge for at least 24 hours.
While charging, the charger may become warm. This is normal and does not indicate a problem. The appliance can be left connected to the charger indefinitely. The charging indicator (5) will be lit as long as the appliance is connected to the
Warning! Do not charge the battery at ambient temperatures below 10°C or above 40°C.
Adjusting the dust collector (fig. D)
Extend the dust collector (2) by pulling the dust collector extension
(1)until it locks into position.
Retract the dust collector extension
(1)by pressing the area (12) marked with an arrow and pushing the dust collector extension (1) back into the dust collector (2).
Switching on and off (fig. E & F)
To switch the appliance on, slide the on/off switch (4) forward.
To switch the appliance off, slide the on/off switch (4) back.
DV1205 & DV9605 - Optimising the suction force (fig. G)
In order to keep the suction force optimised, the filters must be cleared regularly during use.
Slide the filter cleaning button (6) up and down a few times to shake out dust clogging the filters (10 & 11).
ENGLISH
Cleaning and maintenance
Warning! Regularly clean the filters (10 & 11).
Cleaning the dust collector and filters (fig. H - K)
The filters are
Press the release button (3) and remove the dust collector (2).
Empty the dust collector (2) (fig. I).
Remove the filters (10 & 11) by twisting them clockwise (fig. J).
Separate the filters (10 & 11)
Brush any loose dust from the filters (10 & 11).
Wash the filters in warm, soapy water (fig. K). The dust collector (2) can also be washed if necessary.
Warning! Do not immerse the appliance in water.
Make sure that the dust collector (2) and the filters (10 & 11) are dry.
Refit the filters (10 & 11) on to the appliance, twisting them counter- clockwise until they lock into place.
Refit the dust collector (2) onto the appliance. Make sure that the dust
collector clicks into place. Warning! Never use the appliance without the filters. Optimum dust collection will only be achieved with clean filters.
Replacing the filters
The filters should be replaced every 6 to 9 months and whenever worn or damaged. A replacement filter (9) is available from your Black & Decker dealer (cat. no. WVF70):
Remove the old filters as described above.
Fit the new filters as described above.
Storing the accessories (fig. L & M)
Press the accessories into the corresponding holders until they click into place.
9 |