Nozzle/Hose |
Vac Handle |
(Top Position) |
Spring Loaded Pin |
(First Hole) |
Figure 10
IMPORTANT: The flail screen is located inside the housing in the discharge area. If the flail screen becomes clogged, remove and clean as instructed in
SECTION 5: MAINTAINING YOUR YARD VACUUM. For best performance, it is also important to keep the chipper blade sharp.
WARNING: Do not at any time make any adjustments without first stopping engine and disconnecting spark plug wire.
Using the Hose Assembly
•Place nozzle/hose vac handle in the bottom position on the nozzle to redirect vacuum to the hose assembly. See Figure 11.
•The spring loaded pin must be in the second hole of the hose adapter to operate the hose assembly.
•Unhook the hose from upper handle bracket and grasp the hose handle to guide while vacuuming yard waste such as leaves or pine needles in hard to reach places.
Nozzle/Hose |
Vac Handle |
(Bottom Position) |
Spring Loaded Pin |
(Second Hole) |
Figure 11
Nozzle Height Adjustment
The nozzle can be adjusted to any six positions, ranging from 5/8” to 4 1/8” ground clearance. The nozzle height has to be adjusted according to the conditions. Move the height adjustment levers forward or backward to adjust the nozzle upwards or downwards. See Figure 12.
NOTE: In general, raise the nozzle height to vacuum a thick layer of leaves or to operate with the blower chute and lower the nozzle height for smoother surfaces.
| Nozzle Height | |
Nozzle | Adjustment | |
Lever | ||
|
Figure 12
11