MM Owner’s Manual
MOUNTING: Main unit | Typical on |
both sides | |
|
|
GENERAL: Unit must be securely mounted to a trailer, truck bed, or other similar surface before use. Do not use this unit in a freestanding position. Unit is not stable until it has been secured in place.
Secure unit by bolting through the base of the unit and through the mounting surface using 3/8" dia. bolts, with washers and locking nuts (see fig. 1)
MOUNTING: Exhaust elbow
Note: this process is easier with two people, one to support the exhaust elbow and one to attach plates and hardware.
1)Remove the loose hardware from the clamp assembly so that there are 4 separate pieces (two top plates and two bottom plates).
2)Apply good quality grease to the top and bottom of the toothed plate of the exhaust elbow (791114). Also grease top surface of housing and bottom of clamp plates where the gear will rotate.
3)Place the exhaust elbow on the chute with the teeth of the flange against the worm gear and the exhaust holes aligning.
4)Place the two bottom plates on the opposite edges beside the elbow teeth aligning the holes.
5)Place the top plates on top of the lower plates aligning the holes.
6)Secure the assembly with a plate half on top of the elbow flange and a plate half on bottom of the housing flange using 6, 1" carriage bolts and 6 lock nuts (removed hardware in step 1).
Fig. 1
Mount with these holes on both sides
Step 1&2
Part No 791108 | 10 | Form No F111008B |