ELECTRICAL REQUIREMENTS
WARNING - The dispenser must be disconnected from the power source until specified in Initial
Refer to Data Plate on the Brewer, and local/national electrical codes to determine circuit requirements.
WHITE | NEUTRAL WHITE |
NEUTRAL | N |
| |
L1 BLACK | L1 |
| |
| L1 BLACK |
| GREEN |
| G |
120 volt ac models
POWER CORD |
| L2 RED |
|
| L1 BLACK |
|
|
|
NEUTRAL BLUE | POWER CORD | L2 RED | L2 RED | POWER CORD |
N |
|
|
| L2 |
L1 | L1 BLACK |
L1 | |
L1 BROWN | L1 BLACK |
GREEN/YELLOW | GREEN |
| |
G | G |
230 volt ac models | 208 & 240 volt ac models |
Note: This electrical service consists of 2 current carrying conductors (L1 and Neutral) and a separate conductor for earth ground.
Note: This electrical service consists of 2 current carrying conductors (L1 and Neutral) and a separate conductor for earth ground.
Note: This electrical service consists of 2 current carrying conductors (L1 and L2) and a separate conductor for earth ground.
Electrical Hook-Up
CAUTION – Improper electrical installation will damage electronic components.
1.An electrician must provide electrical service as specified.
2.Using a voltmeter, check the voltage and color coding of each con- ductor at the electrical source.
3.Turn off master switch (if equipped).
4.Remove the upper and lower rear panels (side panel on H10X).
5.Install the proper electrical wiring to the terminal block.
6.On Dual Volt models, make sure the toggle switch below the circuit board is set to the desired voltage (120 volts or 208/240 volts) and the red switch on the circuit board is in the “SET” position.
7.Connect the dispenser to the power source and verify the voltage at the terminal block before proceeding. Reinstall both rear panels.
8.If plumbing is to be
L2 RED | L2 RED | POWER CORD |
| L2 |
|
WHITE | NEUTRAL WHITE |
|
NEUTRAL | N |
|
|
| |
L1 BLACK | L1 BLACK |
|
| L1 |
|
GREEN
G
120/208 & 120/240V ac
single phase models
Note: This electrical service consists of 3 current carrying conductors (Neutral, L1 and L2) and a separate conductor for earth ground.
DUAL VOLT TOGGLE SWITCH
CE REQUIREMENTS
•This appliance must be installed in locations where it can be overseen by trained personnel.
•For proper operation, this appliance must be installed where the tem- perature is between 5°C to 35°C.
•Appliance shall not be tilted more than 10° for safe operation.
•An electrician must provide electrical service as specified in conformance with all local and national codes.
•This appliance must not be cleaned by water jet.
•This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experi-
ence and knowledge, unless they have been given instructions concerning use of this appliance by a person responsible for its safety.
•Children should be supervised to ensure they do not play with the appliance.
•If the power cord is ever damaged, it must be replaced by the manufacturer or authorized service personnel with a special cord available from the manufacturer or its authorized service personnel in order to avoid a hazard.
4 | 39338.1 072409 |
|