Genie 2060, TRUE Accessories, Transmitter Compliance Statement, To Replace Remote Control Battery

	Accessories
Transmitter Compliance Statement	C	Programming the
	Programming 1:	Remote Controls

Adjustment 2:	Ch	Setting Contact
		Reverse Function

NOTE

Limit Switch and Force Adjustments must be completed before checking the contact reverse function (Figure MA-3)..

NOTE

•Each Remote Control must be programmed separately..

•The Remote Controls will not cause the door Opener to close the garage door if the Safe-T- Beam® System is malfunctioning..

•When programming the Remote Controls, they must be at least 24” from the Antenna Wire..

•If the red Learn Indicator Light blinks approximately 4 times per second, programming has stopped.. If programming has stopped, repeat the above steps..

•Each Button on a 2 or 3 Button Remote Control is for a different Opener.. You cannot use more than one Button per Remote, per Opener..

•A maximum of seven Remote Controls or Wireless Keypads can be stored into the Receiver at one time.. If a Remote Control becomes lost, or if you want to delete a Remote Control or Wireless Keypad, see “To Erase All Receiver Memory..”

A To program one Button of a Remote Control (Figure MA-4):

• Locate Learn Button and Learn Indicator Light

on left side of Power Head (Figure MA-5)..

• Press and release Learn Button.. Red Learn

Indicator Light will blink 2 times per second..

• Press Remote Control Button once within 30

seconds.. Red Learn Indicator Light will stay lit..

• Press Remote Control Button again.. Red Learn

Indicator Light will go out, indicating that

memory is stored..

AOpen garage door using Wall Console..

BLay a 2” x 4” board flat in center of doorway..

CClose door using Wall Console..

DCheck that door stops and reverses within 2 seconds after it contacts board:

•If door does not reverse, decrease Close Force until door reverses..

•If door still does not reverse, move Limit Switch toward door..

ECheck Safe-T-Beam® System operation:

•If beam is blocked, door will not close..

Figure MA-3

2” x 4” board

laid flat

B Program each additional Remote using step A above

(up to seven)..

To Erase All Remotes from Power Head Memory

APress and hold Learn Button on Power Head for 10 seconds or until Learn Indicator Light goes out.. Memory is erased:

• Program Transmitter/Receiver again as needed..

To Replace Remote Control Battery

A	FOR NON-FLASHLIGHT MODELS
	•	Pop off the back of the transmitter.
		– Use coin, pen, screwdriver or any similar device.
		– Replace old Battery with new coin type battery.
	•	Replace back of remote.
B	FOR FLASHLIGHT MODELS
	•	Slide open battery cover.

NOTE

The door must contact the 2” x 4” board before the Carriage activates the Close Limit Switch.. If not, readjust the Close Limit Switch..

– Replace old Battery with new AAA battery.

• Replace battery cover.

8 For Help, call 1-800-35-GENIE or visit www.geniecompany.com