Allstar Products Group 8833, 9921, 9931, 8822, 8832 Install Your Receiver, Install Your Transmitter

Models 9931, 8832, 8833: The coding switch in these models consist of eight or nine small switches, each of which can be placed in any of three different positions. (+, 0, -). See Fig. 2. Using a small screwdriver, set both the transmitter and receiver coding switches identically. (Your private code setting).

D. Model 8832 -	Double Door Garage
3 2 1	3 2 1
3 2 1	3 2 1

104386

FIGURE 2

DO NOT SET ALL THE SWITCHES IN THE SAME POSITION. EXAMPLE:

NOT ALL or or

IMPORTANT: THE EXACT SAME CODE MUST BE SET ON BOTH THE TRANSMITTER AND RECEIVER. IF JUST ONE SWITCH IS MISMATCHED THE CONTROLS WILL NOT FUNCTION.

(1)(2)

E. Model 8833 - Three Door Garage

3 2 1

3 2 1 3 2 1

MODEL 9921 AND 8822: The coding switch in these models consists of eight or nine small switches each of which can be placed in two different positions, On or Off. See Fig. 3. Using a small screwdriver, set the coding switches in both the transmitter and receiver identically. (Your private code).

DO NOT SET ALL SWITCHEs IN THE SAME POSITION.

EXAMPLE:

NOT ALL or

FIGURE 3
	RELAY		STEP 2: INSTALL YOUR RECEIVER
RADIO		24 VOLTS	A. The receiver was designed to be installed in a
	3 2 1		variety of ways depending on the type of
POWER		COMMON	operator and the application. If standard
			hook-up is not desirable or possible,
			accessories such as three wire adapter sets
			and transformer adapter kits must be used.
		FIGURE 4	B. Standard hook-up to three terminal operators:
			For direct connection loosen the three screws
			on the operator and slide the brass terminals
			under these screws. See Fig. 4. Replace the
			pushbutton wiring and tighten the screws. Be
C. Models 9921 or 9931			certain the antenna wire is hanging down
			vertically and the receiver terminal numbers
Single Door Garage
			printed on the receiver case match the
	3 2 1		numbers on the operator terminal strip.

(1)

(1) (2) (3)

STEP 3: INSTALL YOUR TRANSMITTER

104388

A.The transmitter can be either hand held or mounted on the sun visor with the enclosed visor clip. If sun visor mounting is desired attach the visor clip as shown. (See Fig. 5)

If removal of the visor clip is necessary, place finger in
loop at top of visor clip, and thumb on top edge of
transmitter. Push down with thumb and pull up with
index finger. Clip should release and pull out easily.	FIGURE 5

B.If the operating distance drastically decreases, remove the battery access door See Fig. 1A, and replace the battery with a NEDA 1604, nine volt battery.

C.Models 9921 and 9931: To activate your garage Door or Gate, simply depress your transmitter button until the door or gate starts to move.

D.Models 8822, 8832 and 8833: To activate the desired Garage Door or Gate control, push either button (1) one, (2) two or (3) three, depending on which you desire to open or close. Channel one (1) is the left button. Channel (2) is the center button. Channel three (3) is the right button.

MODELS	MODEL
8822 & 8832	8833