17INSTALLING YOUR E128M WIRELESS WALL BUTTON
Disconnect power to the opener whilst installing this accessory to prevent accidental activation. Locate minimum 1.5 m above the floor
To install:
• Carefully pry open the E128M and locate the two screws for mounting.
• Attach to the wall using the two screws and wall anchors provided if mounting to a plaster wall. If using a box do not use anchors.
+
NOTE: Do not overtighten screws.
NOTE: The wall control supplied with your opener should be
If adding a new wall control, program into the opener before mounting the unit as detailed in section 18.
18WIRELESS PROGRAMING (OPTIONAL ACCESSORIES)
NOTE: Transmitter(s) and wall button supplied with your opener are factory programmed.
Activate the opener only when the door is in full view, free of obstruction and properly adjusted. No one should enter or leave garage whilst the door is in motion. Do not allow children to operate push button(s) or transmitter(s). Do not allow children to play near the door.
Fix any wall control at a height of at least 1.5 m and within sight of the door but away from any moving parts.
| TO ADD Transmitters / Wireless wall button |
NOTE: If adding an installed wall control (E128M) | or |
you will need a second person to press and hold | |
the desired button. If not installed, program the | |
wall button into the opener before mounting. |
|
ADDING transmitters using the LRN “LEARN” | Press and hold down the desired | |
button | Button. | |
• Press and hold down the button you wish to program | LED will FLASH | |
to the opener. |
| |
• The orange LED will flash to indicate it is receiving |
| |
signal from the transmitter. |
| Press LEARN |
• Press and release the “LRN” button. |
|
• The courtesy LEDs will flash once.
transmitter. | Release LRN button when | |
• Ensure the door is clear of obstruction, then test the | Courtesy LEDs | |
| ||
Deleting ALL transmitter codes | flashes once | |
NOTE: This deletes all transmitters and codes | TO DELETE ALL REMOTES | |
•Press and hold the LRN learn button until the orange | ||
Press LEARN for 9 seconds | ||
indicator light goes out (approximatelysec). 9 | ||
| ||
| LED on WILL TURN ON | |
| After 9 seconds all remotes | |
| are deleted and LED will go | |
| out. |
10