Gardena 40002 automatic operating instructions Putting into Storage, Maintenance

GB	Operation of a Micro-Drip-
	System:

The operation of a Micro-Drip-System is possible. Here, the maxi- mum values stated in the accompanying manual of the Master Unit 2000 are reduced. With Art. No. 1742, at least 90 l/h must be

5. Putting into Storage

GB

taken as otherwise the leakage protection is activated.

Storage:

The storage location must not be accessible to children.

Dry-Running Safety:

9

4000/2 (Art. No. 1740):

So that the pump automatically switches off when there is no liquid to pump, the Float Switch 9 must be able to freely move on the surface of the water.

Switch-off height:

If the water level (with the foot fitted) drops below the cut-out level (approx. 25cm), the float switch 9 automatically switches off the pump (Dry-Running Safety).

Switch-on height:

When the water level has risen over the cut-in height (approx. 57cm), the Float Switch 9 automatically switches the pump on.

b

a

v Store the pump away from frost before the first frost sets in.

Transport position:

1.Unscrew telescopic pipe 3 and attach to the side of pump.

Here, ensure that the nose a is slid into the slot b.

2.Wind mains cable 6 around the cable holder 0 and the pump connector 4.

In the transport position, the pump can be carried by the telescopic pipe 3. For easier winding of the mains cable 6, push up the slide bar q of the cable holder 0.

3 4

6

q 0

Automatic mode:

Dry-Running Safety:

Leakage protection:

4000/2 automatic (Art. No. 1742):

The pump automatically switches off as soon as no more water is retrieved. Due to the non-return valve, the pressure is maintained in the hose until water is drawn via the hose. When water is drawn via the hose (the pressure in the hose falls below 1.3 bar), the pump switches on automatically.

When there is no liquid to pump, the pump automatically switches off. The pump then switches in the cycle on 30 sec. – 5 sec.

off (4 x). In 1 hr., 5 hrs., 24 hrs., 24 hrs.... this cycle is repeated.

As soon as the pump stands in at least 4.5 cm water, the pump is ready for operation again.

If there is leakage on the pressure side (e.g. a leaking pressure hose or connecting device), the pump automatically switches on and off in short intervals. When the pump switches on and off more frequently than 7 x in 2 min. (with a leakage less than 3 l/h), the pump switches completely off. When the leakage on the pressure side is eliminated, the pump must be unplugged and plugged in again in order to be operational again.

Disposal:	The product must not be added to normal household waste.
(in accordance with	It must be disposed of in line with local environmental regulations.
RL2002/96/EC)

6. Maintenance
Clean filter:		DANGER! Electric shock!
		There is a risk of injury from electric shocks.
		v Before maintenance, unplug the Rain Water Tank
		Pump from the mains.
	After pumping dirty water, the filter should be cleaned.
e	1.	Press the two locks 1 and remove the foot 2 from the pump.
	2.	Turning suction foot w 1/4 to the left and remove (bayonet lock).
w	3.	Remove e filter and clean under running water.
	4.	Re-install e filter in the opposite sequence.
2

1

12 13