OPERATOR’S MANUAL |
| |
INCLUDING: SPECIFICATIONS, PUMP DATA, SERVICE KITS | RELEASED: | |
INCLUDE MANUALS: Refer to list below. |
| REVISED: |
8” AIR MOTOR | (REV. 01) | |
|
| |
28:1 RATIO | Pump and Cart Assembly |
|
6” STROKE |
|
|
READ THIS MANUAL CAREFULLY BEFORE INSTALLING,
OPERATING OR SERVICING THIS EQUIPMENT.
It is the responsibility of the employer to place this information in the hands of the operator. Keep for future reference.
DO NOT EXCEED MAXIMUM WORKING PRESSURE OF 3360 P.S.I. (231.7 BAR) AT 120
P.S.I. 8.3 BAR) AIR INLET PRESSURE.
SERVICE KITS
•Use only genuine AROR replacement parts to assure compatible pressure rating and longest service life.
•29960 for repair of 27354000 regulator.
•66614 for repair of 66523B air motor.
•104020 for repair of 25351010 filter.
•104023 for repair of 26351010 lubricator.
•637098R43 for repair of 66475R4D lower pump section.
•637103 for repair of 651533 spray gun.
OPERATING AND SAFETY PRECAUTIONS
WARNING READ THE GENERAL INFORMATION MANUAL INCLUDED FOR OPERATING AND SAFETY PRECAUTIONS AND OTHER IMPORTANT INFORMATION.
GENERAL DESCRIPTION
The ARO model NP828C011 pump and cart assembly is designed to provide portability to a pump that is primarily used for airless spray ap plications. Materials of light medium viscosity are best suited for the unit.
IMPORTANT
This is one of the fourteen documents which support the various compo nents of the system. Replacement copies are available upon request.
=NP828C011 Model Operator's Manual (pn 979991024)
- 650865XB TwoBall Pump (pn 97999878)
- S636 General Information Pumping Systems (pn 97999636) - 664758X Lower Pump End (pn 97999111)
- 66523B Air Motor (pn 97999868)
- 66554X Heavy Duty Cart (pn 97999574)
- 66559 Check Valve (pn 97999315)
- 65030XB Filter and Swivel Assembly (pn 97999587)
- 651533X Spray Gun (pn 9799983)
- 651418XB Material Filter (pn 979998)
- 651728X FRL Accessory Kit (pn 97999419)
- WARNING High Pressure Equipment (pn 97999540)
- 253XXX Heavy Duty Filter Regulator Lubricator (pn 103942)
- S632 General Information Industrial Piston Pumps (pn 97999624)
PUMP DATA
NP828C011 Pump and Cart Assembly |
Figure 1 |
OPERATION |
See 650865XB pump manual installation for flushing instructions. Af ter the pump has been flushed with a compatible solvent and is ready for operation:
1.Place 66728 suction hose into material.
2.Connect air line to 6517281 Filter Regulator Lubricator.
3.Turn knob on air regulator clockwise to start pump.
4.Allow pump to cycle slowly and prime with material. This will bleed trapped air from the system.
INSTALLATION
The unit comes completely assembled.
P.O. BOX 151 D ONE ARO CENTER D BRYAN, OHIO 435060151
& (419) | CCN 20051306 |