Operation
Attaching the Accessories
ÎTightly insert the steam plug (C6) into the appliance connector (A1). The plug must click into place audibly.
ÎConnect the required accessories to the steam gun (C1). Insert the open end of the accessory on the steam gun and push onto the steam gun until the un- locking button (C2) of the steam gun locks into place.
Figure 1
ÎUse the extension pieces (G1) if neces- sary. To do so, connect one or both ex- tension pieces to the steam gun (C1).
Insert the required accessories on the free end of the extension piece.
Figure 2
Removing the Accessories
DANGER
Hot water may drip out of the accessory parts while you are detaching them! Never detach accessory parts while steam streams out - risk of scalding!
ÎPush the lock (C3) to the front (steam switch blocked).
ÎTo detach the accessory parts, press the unlocking button (C2 or G2), and pull the items apart.
Figure 3
Fill up with water
Note: If you always use usual commercial distilled water it is not necessary to descale the boiler.
CAUTION
Do not use condensation water from the drier! Do not fill in detergents or other addi- tions!
ÎRemove the safety clamp (A3) from the device.
ÎEmpty remaining water from boiler.
ÎFill the boiler with a maximum of 1.2 lit- ers of fresh tap water.
Note: The boiler can be filled up to 2 cm below the edge of the filler neck. You can cut down the
ÎScrew the safety clamp (A3) back onto the device.
English 7