Oreck XLS465A warranty To Clean Carpet Cleaner, To Store Cleaner, Things To Do

To Clean Carpet Cleaner

WARNING: To reduce the risk of electric shock or injury from moving parts, unplug before servicing.

1.Before turning the cleaner off, tilt the cleaner back, raising the nozzle off the carpet for 15-20 seconds. This prevents extracted water in the nozzle from dripping back onto the carpet after you turn the cleaner off.

2.Place the red power switch in the ”Off“ position. Unplug the power cord from the outlet.

3.Remove the cleaner cartridge by rotating the locking white lever upwards. Do not store with a cleaner cartridge attached.

To Store Cleaner

24

1.	Pull the wheel assembly forward toward nozzle
	for compact storage (Figure 24).
2.	Do not store the cleaner in freezing conditions.
3.	Do not store the cleaner with water in the tank.
4.	Do not store the cleaner with cleaner cartridge

Inlet 21

Screen

C:Spray Tips

B: Brush

Roll

Chamber

A: Extractor Slots 22

23

4.Remove and empty the tank. Rinse out the lower recovery tank with warm water. Wipe off the inlet screen to remove accumulated dirt, lint and debris (Figure 21). Replace tank (Figure 8).

5.If you have been operating the cleaner at length, it may be necessary to clean the nozzle from time to time, particularly if the carpet is brand new or very dirty, or if long-haired pets frequently use the carpeted area (Figure 22).

6.Unplug cleaner and examine several areas on the power nozzle (Figures 22-23) to see if debris has built up:

A:Extractor slots (Figure 22-A)

B:Brush roll chamber (Figure 22-B)

C:Spray Tips

(Figure 22-C)

attached.

Things To Do

Use only manufacturer recommended attachments and accessories.

•Keep free of dust, lint, and hair.

•Turn off all controls before unplugging.

•Test the A.L.C.I. plug with every use.

•Empty the recovery tank when full and whenever clean water is added to the supply tank.

•Keep young children and pets away from cleaned carpets until dry.

•Check carpets and upholstery for color fastness.

•Clean nozzle periodically.

7.To clean the STEEMER extractor slots, place a cloth or towel over the motor cover to shield and protect the motor from water damage. Run hot tap water through the nozzle until clean (Figure 22).

8.To clean the brush chamber and spray tips, take a towel or damp cloth and wipe clean. (Figure 23).

10