Sears 680.88973 owner manual Handle Switch BOX and Cord, Upper

DO NOT PLUG IN ELECTRIC CORD UNTIL BRUSHES OR OTHER ACCESORIES HAVE BEEN ATTACHED AND SWITCH HAS BEEN PLACED IN THE "OFF"POSITIQN.

HANDLE,

SWITCH BOX AND CORD

. Place lower handle tube (Fig.l)into handle tube socket"A" (FIG.2). Fasten using bolt "'B" and internally threaded nut "C" (FIG.3) provided in the hardware package.

If the handle tube is difucult to assemble (tight), insert blade of screwdriver into slot (FIG.4) at rear of handle tube socket and twist screwdriver gently while inserting han- dle tube.

2.Place upperhalf handle tube (FIG.l) over lower half.Aling holes and fasten with remai- ning bolt "B':and internally threaded nut "'C".

Attach switch box to rear of upper handle tube.Palce switch box tab (no hole) into rec- tangular hole (FIG.5). Position box against handle tube. Fasten using the small screw

provided in the hardware package. DO NOT OVERTIGHTEN.

,The motor cord, which goes from the switch box to the bottom of the unit, is attached in

two (2) locations behind the dispenser at top and bottom. The upper part of the motor cord is snapped into place alongside the upper cord hook on the dispenser top (FIG:6).

The lower part of the motor cord is snapped into place between the two lower cord hooks.

They are located on the dispenser base (FIG.

7).

. Attach lower plastic hose to rear of unit by inserting the fitting on the end of hose into hole located midway at rear of unit (FIG.8).

6.The electric cord is wound around cord hooks as illustrated in (FIG.9).

NOTE:

All moving parts requiring lubrication have been permanently lubricated at the factory.

Assembly

Instructions

B o=" ,_ '=_C

TUBE

FIG. 2

UPPER

_2JHANDLE TUBE

FIG.1

FIG. 3

r'-,<

o

I

i E

FIG. 4 FIG. 5

FIG. 6

FIG. 8 FIG. 9