Shark S3501WC manual Using Your Steam Mop cont’d, Using Your Carpet Glider

Using Your Steam Mop - cont’d

4

3

Using Your Carpet Glider English

The Steam Mop won’t clean your carpeting or area rugs. However, it’s great for deodorizing and freshening.

1

3For your comfort, you can adjust the height of the mop. Just lift the latch on the tube 90 degrees to the open position. Holding the handle, extend the tube to the height that’s right for you and then close latch to locked position.

4When one side of the micro-fiber pocket gets dirty, just flip the mop head and you can quickly start using the other side. Dirt can’t hide on either side.

IMPORTANT: Please wait 3-5 minutes for the Steam Mop to cool off before switching the mop head or the micro-fiber pockets.

6 TOLL FREE: 1-866-538-6109

S3501WC_IB_English_100119.indd 6-7

5When the water tank is empty, the steam mop will stop producing steam. You can refill the water tank at any time as long as the mop is unplugged from the outlet. Follow the instructions from page 3. This goes for switching the mop heads or micro-fiber pockets as well.

IMPORTANT: Never leave the steam mop with a damp/wet micro-fiber pocket on any floor surface for any amount of time as this may damage the floor.

THE CARPET GLIDER

1The Carpet Glider can be used with the rectangle mop head to lightly steam your carpet and area rugs. Just place the mop head on top of the glider and move back and forth across a section of the carpet. The steam mop won’t clean your carpeting or areas rugs, but it’s great for deodorizing and freshening.

NOTE: Please note that the Steam Mop rests on top of the carpet glider and it is not a fixed attachment.

Do not leave steam mop with carpet glider in one stationary position for any period of time.

www.sharkclean.com 7

1/19/10 2:48 PM