Earlex SS200 manual Guarantee, EC Declaration of Conformity, Mains Connection

Page 7

GUARANTEE

This product is guaranteed for a period of 2 years against faulty materials and workmanship. The guarantee specifically excludes the use for hire and rental purposes. Whilst every possible care is taken by Earlex to ensure that our products leave the factory in good working order, Earlex cannot under any circumstances accept liability for problems or damage caused by use of such products not in adherence to the instructions enclosed. Any unit that has been modified in any way or used on incorrect voltage will not be covered by the guarantee. Consumables such as filters are not covered by the guarantee. This guarantee does not affect your statutory rights. In the event of a fault occurring, please contact our helpline before returning the unit to our Service Department at the address below, together with a copy of your purchase receipt. All repairs will be dealt with speedily.

EC Declaration of Conformity

We declare that the unit SS200 conforms to: 2006/95/EC, EN60335-1, EN60335-2-54, 2004/108/EC, EN55014-1,

EN55014-2, EN61000-3-2, EN61000-3-3 & EMF EN 50366.

Tim Hopper - Technical Director

MAINS CONNECTION

This product is supplied with a specially prepared mains lead, if the cord is damaged, it must be replaced by the manufacturer, its service agent or similar qualified persons in order to avoid a hazard.

Please read the following safety instructions before use.

1.If the moulded plug is cut off from the mains lead then the plug must be disposed of safely. NEVER under any circumstances insert such a plug into a 13 amp socket.

2.NEVER under any circumstances use the appliance or mains lead without the fuse cover fitted. This is the little cover fixed into the base of the plug to hold the fuse in place.

3.If you lose the fuse cover then please contact our helpline on 01483 454666.

4.A replacement fuse must be rated at 13 amp. These must be manufactured and approved to BS1362.

5.IF IN ANY DOUBT, PLEASE CONTACT AN ELECTRICIAN.

If you are using an extension lead it must be rated at a minimum of 10 amps and fully unwound. Do not operate with a lead rated at less than 10 amps as this will cause premature failure of the motor which is not covered by the guarantee.

7

Image 7
Contents Model SS200 Symbols Safety Rules Please Read CarefullySET UP Whats Included Parts ListDo not PreparationOperation Filling StrippingCompletion & Storage HOW to Assemble the Spare Vacuum CUP Steam Plate FilterArtex Safety CUT-OUTTroubleshooting Other UsesIf in ANY DOUBT, Please Contact AN Electrician GuaranteeEC Declaration of Conformity Mains ConnectionCombiVac Workshop Vacuum & Blower WD1000 Other Products in the Earlex Range