Bissell 1425 warranty Operation, Getting ready, Pre-treating

				WARNING:
Operation				Do not use an extension cord with this
				product. The use of an extension cord may
				result in a severe electrical shock, particu-
Getting ready				larly if the extension cord does not have
				an electrical rating higher than that of the
1.	To fill the clean/solution tank.			product, OR if the extension cord does not
				have a three-prong grounding plug
	A. Remove the tank by lifting it straight up
				and if the extension cord is not plugged
		and then away from the unit.		into a circuit box with a ground fault circuit
	B.	Unscrew the black cap at the bottom of the		interrupter. Safety precautions such as
				keeping all connections off the ground and
		clean/solution tank and remove bottle insert.
				dry will not eliminate the danger.
	C. Add BISSELL Little Green formula to the
		FORMULA fill line (8 oz.) on the clean/solution		WARNING:
		tank. Fill the clean/solution tank with hot (NOT
		boiling) tap water to the WATER fill line. Replace
				Use only BISSELL Little Green formula
		the bottle insert and tighten the black cap.		in your cleaner. Use of cleaning
	D.	Replace the clean/solution tank by lining up		formulas which contain lemon or
				pine oil may damage this appliance
		the vertical guides on the left side of the unit
				and void the warranty. Chemical
		with the indentations on the clean/solution		spot cleaners or solvent-based soil
		tank and gently sliding it down into position.		removers also should not be used.
2. Release vacuum flex hose by twisting the				These products may react with the
				plastic materials used in your cleaner,
	bracket latch clockwise. Unwrap vacuum flex			causing cracking or pitting.
	hose completely from around unit.
3.			1A	1B
	Attach the tough stain brush tool to the spray
	trigger unit by pressing tool onto spray trigger
	firmly until the button lock snaps into hole.
	Make certain the tool is securely attached.
4.	Twist the Quick Release cord wrap clockwise
	to unwrap the power cord completely from
	onboard cord storage and plug into 120 Volt		1C	1D
	grounded outlet, as described in Important

Safety Instructions, page 3. The heat indicator

light will take 30 seconds to illuminate. Water

5.Press and hold spray trigger—spray will start in a few seconds. Raise the tool slightly

to check for spray. Formula

Pre-treating

Cleaning effectiveness will be enhanced if you pre-treat heavily stained or highly-soiled areas. Here’s how to do it:

1.Hold the cleaning tool just above the surface of the carpet or upholstery to be cleaned. Press the trigger to release a spray of cleaning solution directly onto the soiled area.

2.Wait 3-5 minutes before cleaning.

2

4

3

5

WARNING:

Do not use this product while on any type of ladder. Do not place the product in a place where it will be stepped on or kicked while in use. Do not place the product on an elevated surface where it may be pulled off the surface while in use.

w w w . b i s s e l l . c o m

8 0 0 . 2 3 7 . 7 6 9 1 5