4. Maintenance
R e m o v a b l e brushes
Your deep cleaner is equipped with removable brushes for easy cleaning.
To remove bru s h e s
Disconnect cleaner from electrical outlet.
To prevent possible leaking, remove clean solution tank and recovery tank. Set tanks aside.
| B |
|
| A |
| B |
| B |
Press handle release pedal to lower han- | Grasp inner portion of brush (A) and pull |
dle. Turn cleaner over so bottom is fac- | brush assembly out slightly to reveal |
ing up. | latches (B). |
B
B
B
B
Press all four latches (B) and pull brush block out. The brushes can be cleaned under running water.
D
EF
D
C
To replace bru s h e s
Align posts (C) on both ends of brush assembly with slots (D) in cleaner hous- ing.
Make sure that square post (E) also aligns with square hole (F). Turn brush- es slightly until post fits easily into hole.
Press brush assembly firmly to snap into place.
S t o r a g e
Before storing:
•Empty solution tank and rinse thoroughly with clean water.
•Replace empty solution tank and turn deep cleaner ON. Squeeze trigger and push deep cleaner for- ward and back several times to
expel any solution remaining in the deep cleaner’s system. (Do not use deep cleaner on wood floors.)
•Empty recovery tank and rinse thoroughly with clean water.
Allow brushes and underside of deep cleaner to air dry thoroughly before storing deep cleaner on a carpeted or wood surface.
Do not store deep cleaner with a full solution tank In place.
Lubrication
The motor Is equipped with bearings which contain sufficient lubrication for the life of the motor. The addition of lubricant could cause damage. Do not add lubricant to motor bearings.
Service
To obtain approved HOOVER service and genuine HOOVER parts, locate the nearest Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot) by:
•checking the Yellow Pages under Vacuum Cleaners - Household” OR
•checking the list of Factory Service Centers provided with this cleaner OR -
•calling
•checking the Service section of The Hoover Company
Please do not send your cleaner to The Hoover Company in North Canton for service, this will only result in delay.
If further assistance Is needed, contact The Hoover Company Consumer Response Center, North Canton, Ohio 44720 Phone:
Always identify your cleaner by the com- plete model number when requesting information or ordering parts. (The model number appears on the bottom of the cleaner.)
11