Step 1 Assemble handle
A
Note: The green or white switch lock (A) near the ON/OFF switch on the back of the bag compartment assembly, helps in assembling your cleaner.
Assembly can be continued if the switch lock is missing. However, do not remove the switch lock until assembly is completed.
Removing bag door
Pull bag door latch forward and remove bag door.
Set bag door aside.
AA |
Attaching cord
Slide cord protector (AA) away from rectangular end of cord.
Insert large rectangular end of cord through opening in back of bag compartment.
UP
With side marked “UP” visible, insert end into pocket in the bottom of the bag compartment assembly.
Slide cord protector toward top of bag assembly and slide through opening.
B
C
With bag compartment in the verti- cal position, rotate cord protector
(B)on cord so that the arrow is on the side.
Press protector into the slot (C). Pro- tector should be pointing downward when assembly is in the verticle position.
Pull cord tight.
UP |
Press cord into place at each of the three slots indicated.
Do not plug cleaner in until assembly is totally complete.
D
Attaching bag compart- ment assembly
Remove cardboard protector from bottom of bag compartment assem- bly.
With opening of bag assembly toward the front, place it down onto the extension on cleaner base.
Rock handle side to side while pushing down firmly. Extra push- ing effort may be required. Make sure handle is pushed down com- pletely.
Push bolt into hole (D) on lower front of assembly.
Place nut in recessed area at back of assembly. Hold nut in place while tightening bolt securely with a screwdriver.
Only one nut is needed on this model. The extra nut is not required but has been provided for your con- venience.
4