Everpure EV9982-24 manual Water, and electrical costs, Regeneration, Between refills, Warewashing

C E S 2 7 5 0 S e r i e s

W a t e r C o n d i t i o n e r

Water Conditioning for Commercial and Light Industrial Applications

Available in Single Tank System with 1” Porting

			B E N E F I T S
			Hardness removal of 34,000 to 101,000 grains at
			flow rates up to 20 gallons per minute continuous
			Meter initiated regeneration minimizes salt,
			water, and electrical costs
			Advanced user-friendly controls incorporates
			time-tested hydraulically balanced piston,
			seal and spacer design to pilot service flow
			and regeneration
			Large capacity brine tank maximizes time
			between refills
			Fiberglass reinforced resin vessels with NSF
			approved polyethylene liners eliminate worries
			about corrosion
			Single tank design for simplicity, economy
	CES-2750M34:	EV9982-21	and space savings
	MRS-20T System: EV9797-92
	CES-2750M-51:	EV9982-22	Fully adjustable 5-cycle control delivers
	CES-2750M-68:	EV9982-23
			controlled upflow backwash, downflow brining
	4MR-1 Cartridge: EV9273-69
	CES-2750M-101:	EV9982-24	and slow rinse, rapid rinse, timed brine refill and
			downflow service
I N S T A L L A T I ON T I P S	OP E R A T I ON T I P S		A P P L I CA T I ON / S I Z I N G
Locate equipment on a smooth, level surface	Check for softened water each time salt is		Warewashing
Maintain an air-gap at the end of the drain line	added, by using a soap or hardness test kit		Laundry - Linen & Uniform
	Use a good quality grade of salt -Solar
Secure drain line directly over floor drain or	or pellet are preferred		Boiler Scale Control
stand pipe	Check the salt level on a regular basis		Water Heater Scale Protection/Reduction
When connecting to a water heater, install a
	Maintain at minimum salt depth of 6” to		General Housekeeping
check valve on the soft water piping to prevent
hot water back-up	ensure a proper regeneration
When sweating/installing copper piping,	On iron bearing waters, use a salt that
protect the control valve from excessive heat	contains an iron “fighting” additive, or use
Check local codes for additional equipment	a resin cleaner on a regular basis
	Check the water level in the brine tank
that may be required, such as backflow
prevention devices (i.e., RPZ)	If abnormally high - refer to IO guide for
	troubleshooting information