Brother NX 200 manual Shutter

GETTING READY ———————————————————————————————————————————————————

CAUTION

●If the spool or the spool cap is not positioned correctly, the thread may become tangled around the spool pin or the needle may break.

●Three spool cap sizes are available (large, medium and small), allowing you to choose a spool cap that best fits the size of spool being used. If the spool cap is too small for the spool being used, the thread may catch on the slit in the spool or the needle may break.

8While holding the spool with your right hand, pull the thread with your left hand, and then pass the thread behind the thread guide cover to the front.

1

1Thread guide cover

9Pass the thread under the thread guide plate from the right.

1

1Thread guide plate

0While using your right hand to hold the thread passed under the thread guide plate taut, pass

the thread through the guides in the order (up → left → down → up → down) shown.

1

1Shutter

The following diagram shows the shutter position when the presser foot is lowered. Since the shutter is closed when the presser foot is lowered, the machine cannot be threaded. Be sure to raise the presser foot so that the shutter is open in order to thread the machine.

1

1Shutter

aPass the thread through the thread hook at the base of the needle bar.

1

1Thread hook

Next, use the needle threader to thread the needle. Continue with the procedure in “Threading the needle” (on the next page).

CONTENTS GETTING READY SEWING BASICS UTILITY STITCHES APPENDIX

INDEX

20