Operations, Cues, Troubleshooting, Specifications

TIME/OUTRO: The TIME BUTTON (17) switches the time display between the 4 available choices listed under DISPLAY (12). This also swithces on/off the Outro function, which only plays the last 30 seconds of each track.

PITCH: Pushing the PITCH BUTTON (20) activates the PITCH CON- TROL SLIDE (21). The pitch of the CD will change according to the posi- tion of the PITCH CONTROL SLIDE (21).

PITCH BEND BUTTONS: Pushing the PITCH BEND BUTTONS

(22)will automatically raise the pitch up to +16% or lower the pitch down to -16% from the existing pitch setting. Releasing the buttons will return the pitch to the original pitch setting. You can use this function to match the pitch bend when mixing from one song to another.

PITCH CONTROL SLIDE: Moving the PITCH CONTROL SLIDE (21) up or down will lower or raise the pitch percentage.

OPERATIONS:

1.Press the OPEN/CLOSE (8) button, place a CD in the DISC TRAY (7) and press the OPEN/CLOSE (8) button again. The tray will close into the unit.

2.Push the TRACK SKIP(14) buttons to select the track you want to play.

3.Press the PLAY/PAUSE (10) buttons and the unit will instantly play.

CUES:

1.To program a cue point (the spot on a CD at which you want play to start) select a track and push PLAY/PAUSE (10) so the unit enters the PLAY mode. (PLAY/PAUSE LED glows green).

2.When the CD reaches the approximate musical spot you wish to make your cue, push PLAY/PAUSE (10) so the unit enters the PAUSE mode (PLAY/PAUSE LED blinks and the unit will enter stutter mode). Move the SEARCH DIAL (9) forward or in reverse until you reach the precise frame is located, at which point you will want the CD to begin play. Push CUE (11). The cue point is now programmed, the blue LED will remain on. Press and hold CUE (11) to preview the cue point. Release CUE (11) to return to the cue point. Press CUE (11) to return to this pre-programmed cue point and play at any time.

Note: Once you have skipped to another track, you may not go back to your programmed cue point. You must begin your cue selection over again once you have skipped to another track. The cue will be preset to the beginning of the selected track. Press the cue button and you will begin at the beginning of your selected track. Start your Cue programming sequence over again.

3.To fine tune your pre-programmed cue point, push the CUE (11) button and the CD will return to the cue point you programmed in step #2. Push PLAY/PAUSE (10) so the unit enters the PAUSE mode at that point. Use the SEARCH DIAL (9) to move forward or backward to find the proper Cue point. Repeat step #2. If you decide this cue or starting point is okay, leave the unit alone until you are ready to play.

4.If, however, the selected spot is not exactly where you want it, push the CUE (11) button while the CD is playing and the disc will return to the pre- programmed cue point. Repeat step #1 - #3.

NOTE: During fine tuning there will be a stutter effect (to help you find the beat). The stut- tering effect will end when you press the PLAY/PAUSE (10) to save the cue point.

TROUBLESHOOTING:

·If the disk will not play, check to see if the disc was loaded correctly (label side up). Also check the disc for excessive dirt, scratches, etc.

·If the disc turns but there is no sound, check the cable connections. If they are okay, check your amplifier or receiver.

·If the CD skips, check the CD for dirt or scratches. Do not assume that the CD player is defective. Many CDs are recorded out of spec and will skip on most or all CD players. Before sending the unit in for repair, try playing a CD that you are sure plays properly.

SPECIFICATIONS:

GENERAL:

Type	Compact Disc Player
Disc Type	Standard Compact discs (12 cm & 8 cm)
Time Display	Track Elapsed, Track Remain, or Total remain
Variable Pitch	± 16% Slider with Resume Switch
Pitch Bend	± 16% Maximum
Instant Start	Within 0.03 seconds
Track Selection	1 to 99 Tracks
Installation	19" each
Dimensions	19” x 3.5” x 10”
Weight (total)	10.21 lbs. (6.21 Kg)

AUDIO SECTION:

Quantization	1 Bit Linear/Channel, 3 Beam Laser
Oversampling Rate	8 Times
Sampling Frequency	44.1 kHz
Frequency Response	20 Hz to 20 kHz
Digital Output	IEC958
Total Harmonic Distortion	Less Than 0.05%
Signal to Noise Ratio	85 dB
Dynamic Range	85 dB
Channel Separation	85 dB
Output Level	2.0 +/- 0.2V R.M.S.
Power Supply	AC 115/230V, 60/50 Hz

Specifications and design are subject to change without notice for purpose of improvement.

(5)

CDX-02 specifications

The Gemini CDX-02 is a cutting-edge vehicle that has garnered attention for its innovative design and multifaceted capabilities. As a model that represents the next step in automotive technology, the CDX-02 combines efficiency, performance, and safety, making it a strong contender in the competitive automotive market.

One of the standout features of the Gemini CDX-02 is its advanced powertrain. Equipped with a hybrid engine, it offers both electric and gasoline options, effectively striking a balance between fuel efficiency and power. The electric motor allows for a silent and eco-friendly driving experience, especially in urban environments, while the gasoline engine provides the necessary power for longer journeys.

The design of the CDX-02 is sleek and aerodynamic, enhancing its performance and reducing drag. The exterior features bold lines and modern aesthetics, making it visually appealing to a wide range of consumers. The use of lightweight materials in its construction not only boosts performance but also contributes to overall fuel efficiency.

Inside, the Gemini CDX-02 boasts a high-tech cabin that focuses on driver comfort and connectivity. A large infotainment system with a touchscreen interface allows for seamless integration with smartphones and other devices. Advanced voice recognition technology enables hands-free commands, ensuring that drivers can stay focused on the road.

Safety is a priority in the CDX-02, equipped with a suite of advanced driver-assistance systems (ADAS). These features include adaptive cruise control, lane-keeping assist, and automated emergency braking, all designed to enhance the safety of both the driver and passengers. The vehicle also has a robust airbag system and reinforced safety cage, contributing to its high safety ratings.

In terms of customization, the Gemini CDX-02 offers various trim levels and optional packages that allow buyers to tailor the vehicle to their preferences. This flexibility makes it appealing to a diverse audience, from tech-savvy individuals to families seeking a reliable car.

Overall, the Gemini CDX-02 encompasses a blend of modern technology, performance, and safety features, making it a desirable choice for discerning drivers. With its forward-thinking design and an array of advanced technologies, the CDX-02 stands as a symbol of the future of automotive engineering.