Technical Information
Recommended water pressure | 14.7 - 72.5 psi | |
Max. water pressure | 147 psi | |
Recommended hot water temp. | 120� - 140� F* | |
Max. hot water temp | 165�F* | |
Hole size in mounting surface | 1 | 1/4” valves, 1 3/8” spout |
Max. mounting surface depth | 1 | 1/2” |
Flow rate | 2.2 gpm | |
Requires 1/2” supply lines (not included) |
|
|
*Please know and follow all applicable local plumbing codes when setting the temperature on the water heater. In Massachusetts, the water heater may be set no higher than 112oF.
Installation
Install the hot and cold valves
Install the mounting nut, metal washer and the fiber washer on the valve.
Insert the valve through the hole in the deck. The hot valve is marked with a red dot.
Install the stop ring on the valve. Thread the mount- ing plate on the valve until the stop ring stops it at the proper height.
Rest the valve on the mounting surface. Turn the valves so that the outlets point toward the center.
Tighten the mounting nut. Tighten the tensioning screws.
Install the spout
Swing C and Limbo C only: Place the spout, deco ring, and sealing ring on the mounting surface.
All other models: Place the spout and sealing ring on the mounting surface.