Bose 3 Series manual Cleaning your speakers, Troubleshooting

Page 11

Maintaining Your Acoustimass® Speaker System

Cleaning your speakers

Clean the cabinets of your Acoustimass® 3 system using a damp cloth. If necessary, use a mild detergent such as dish soap. Do not use any solvents, chemicals, or cleaning solutions containing alcohol, ammonia, or abrasives. Do not allow liquids to spill through the speaker grilles or enter the Acoustimass module.

You can vacuum the speaker grilles. To avoid damaging the drivers located directly behind the grille cloth, use light pressure only.

Troubleshooting

 

If you have a problem with your Acoustimass 3 speaker system, turn off the amplifier or

 

receiver and check all the connections between the cube speakers, the module, and amplifier

 

or receiver. Since problems are likely to originate with components other than speakers, you

 

may want to refer to your amplifier or receiver owner’s guide.

 

 

Problem

What to do

 

 

The left cube speaker does

• Disconnect both speaker cables from the amplifier or receiver. Reconnect the cable from

not play or sounds distorted.

the bass module’s L INPUTS to the amplifier or receiver’s RIGHT speaker terminals.

 

Set the amplifier or receiver’s balance control all the way to the right and turn on the power.

 

• If the left cube speaker now plays properly, your amplifier or receiver’s left speaker channel

 

is probably defective.

 

CAUTION: DO NOT connect the other cube speaker to the channel in question. If the

 

channel is defective, it could damage your Acoustimass 3 system.

 

 

The right cube speaker does

• Follow the above steps, reconnecting the cable from the module’s R INPUTS to the

not play or sounds distorted.

amplifier or receiver’s LEFT speaker terminals.

 

 

The entire Acoustimass 3

• Disconnect the amplifier or receiver from the bass module. Reconnect the module to

system does not play or

another amplifier or receiver that is working properly.

sounds distorted.

• If the system now works, the problem is in your amplifier or receiver. Refer to your receiver

 

or amplifier owner’s guide for further suggestions.

 

• If trouble persists in your Acoustimass 3 speaker system, contact your authorized Bose®

 

dealer who will verify any defects and arrange for service by an authorized agency or by the

 

Bose factory. Bose will make every effort to remedy any problem within the terms of the

 

warranty at minimum inconvenience to you.

 

 

AM252171_02_V.pdf

October 22, 2001

9

Image 11
Contents Bose Acoustimass 3 Series IV Speaker System Declaration Conformity Thank youPlease read this owner’s guide Information about products that generate electrical noise Antenna grounding For your records Where to find …Selecting locations for the cube speakers Before you beginUnpacking the system Selecting a location for the Acoustimass module Using the cables correctlyConnecting the cube speakers to the Acoustimass module Checking your connections Understanding automatic system protection Checking the systemTroubleshooting Cleaning your speakersTechnical information Warranty periodCustomer service October 22 October 22 October 22 Belgique/België CanadaEuropean Office Australia