Installation Instructions

	Bradley Drench Shower - Horizontal Supply
Installation Instructions	Model No. E19-120A

Supplies Required:

•Pipe sealant

•Piping to 1” BSP water supply inlet on unit

•Adequate supply pipe supports

•Minimum 102 mm (4”) drain to accommodate 115 liters per minute discharge for drench shower waste

Step 1: Assemble drench shower

NOTE: Flush the water supply line before beginning installation.

1.Assemble drench shower components as shown in Figure 2 on page 4.

2.Apply pipe sealant or tape (supplied by installer) to all male-threaded pipe joints.

NOTE: Use a strap wrench around the pipes when tightening to prevent mm-ring.

3.The bottom edge of the showerhead should be 2134 mm (7-O”) from the floor.

Step 2: Connect water supply

IMPORTANT: Do not rely on Bradley’s Drench Shower to support supply piping.

-J

Figure 1

1.Connect water supply piping to l-1/4” BSP inlet on unit (piping supplied by installer). Provide adequate supports (supplied by installer) for supply pipe using pipe hangers or other means.

2.Mount safety sign to wall or pipe using sign mounting hardware supplied.

3.Open water supply lines. Test for leaks and adequate water flow.

Installation Instructions continued.. .

Bradley Corporation • 215148AE Ref. G; EN 98-579