American Standard 2804 Install POP-UP Drain, Install Black Gasket, Install Gray Locknut

2 INSTALL POP-UP DRAIN

Remove CLEAR PLASTIC COVER (1). Remove CARDBOARD SPACER (2) from under DRAIN POP-UP (3). Fig. A.

Drop DRAIN BODY (4) through sink drain hole. Make sure WHITE FOAM GASKET (5) is under flange of DRAIN BODY (4). Fig. B.

Note: No plumber’s putty or caulk is required.

The CABLE ATTACHMENT POINT (6) must face towards the rear of the SINK. Fig. B.

Fig. A.

1

3

2

Fig. B.

REAR OF

SINK

4

5 6

SINK

DRAIN

HOLE

3 INSTALL BLACK GASKET

Install BLACK CONE GASKET (1) onto DRAIN BODY (2) from below.

Note: The flat side of the BLACK CONE GASKET (1) must face down.

2

1

FLAT SIDE OF GASKET MUST FACE DOWN

4 INSTALL GRAY LOCKNUT	Fig. A.		Fig. B.
Install GRAY LOCKNUT (1) onto DRAIN
BODY (2) from below SINK. Fig. A.
Note: The flat side of the GRAY LOCKNUT (1)
must face up.		2
Tighten firmly by hand. No tools are required.			DRAIN
Check DRAIN FLANGE in SINK to ensure that			FLANGE
WHITE FOAM GASKET (3) is fully compressed			FLAT SIDE OF
and not visible. Fig. B.			GRAY LOCKNUT
			MUST FACE UP
		1	3 WHITE FOAM
			GASKET
			NOT VISIBLE
5 POP-UP KNOB			DOWN
POP-UP KNOB (1) must be fully down.			1

M968422 Rev . 1 . 2

2