American Standard 4508.4 Install Handles, Test Installed Fitting, Check Drain Connections

11 INSTALL HANDLES
Push ADAPTER (1) on VALVE STEM (2), so that the hole of the
ADAPTER (1) without a spline is facing up. See figure "A". Tighten		THREAD ON
STEM SCREW (3) to secure ADAPTER (1).
		TO DECK
Find correct position of LEVER HANDLE ASSEMBLY (4) by adjusting	4	ADAPTER
male teeth on ADAPTER (1) to female teeth in HANDLE (4).	TOP
Thread LEVER HANDLE ASSEMBLY (4) onto DECK ADAPTER (5)		1
until snug against mounting surface.
		3
Figure "A"
		2
SPLINE END DOWN		5
12 TEST INSTALLED FITTING		OUTLINE OF BIDET

With HANDLES (1) in OFF position, turn on WATER SUPPLIES (2) and check all connections for leaks.

Operate both HANDLES (1) to flush water
lines thoroughly.	1
Rotate TRANSFER VALVE (5) from rim wash to
spray several times to check operation.

3

1

13 CHECK DRAIN CONNECTIONS
Pull up POP-UP KNOB (3) and fill Bidet with water. Check	4
that DRAIN STOPPER (4) makes a good seal and retains		2
water in Bidet. If STOPPER (4) does not seal properly,

please refer to “Troubleshooting Guide” in these instructions.	SPRAY
Push POP-UP KNOB (3) down and check all drain
connections and "P" trap for leaks. Tighten
if necessary.

2

14 CARE INSTRUCTIONS:

DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER.DRY WITH A SOFT COTTON FLANNEL CLOTH.

DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.

15			SERVICE
					HANDLE
	To change direction of handle rotation,				ASSEMBLY
	proceed as follows:			UNTHREAD
		Turn valve to OFF position. Unthread HANDLE
		BASE (1) from DECK ADAPTER (2).
		Pull HANDLE ASSEMBLY off VALVE STEM (3).		1
		Remove SPRING CLIP (4). Lift STOP WASHER (5),

turn 90˚ and replace. Replace SPRING CLIP (4).

Find correct position of HANDLE ASSEMBLY by adjusting 90˚		3
male teeth on VALVE STEM (3) to female teeth in HANDLE.		5
Thread HANDLE ASSEMBLY onto DECK ADAPTER (2)	4
until snug against mounting surface.

If spout drips, operate handles several times from	2
OFF to ON position. Do not force - handles turn
only 90˚ .	M968845 Rev . 1 . 2

4