American Standard 4501 Install Trim, Adjust HOT Limit Stop HOT Limit Safety Stop Adjustment

2 INSTALL TRIM			3
When finished tiling the wall, remove PLASTER GUARD (3).		4
Push on CAP (1).
Mount ESCUTCHEON (2) and with SCREWS (7).			5
Install HANDLE (8) by pushing it onto CARTRIDGE STEM (9)
and tightening SET SCREW (10) from below with 2.5mm
Hex Wrench supplied. Insert INDEX BUTTON (11).			2
Remove cap from tub supply and plug from shower pipe.
	9
Install SHOWER ARM with FLANGE (4) and SHOWER HEAD (5).	1		7
Install DIVERTER SPOUT (6).
			8
			10
		6	11

3 ADJUST HOT LIMIT STOP

HOT LIMIT SAFETY STOP ADJUSTMENT

By restricting handle rotation and limiting the amount of hot water allowed to mix with the cold, the HOT LIMIT SAFETY STOP reduces risk of accidental scalding. To set the maximum hot water temperature of your faucets, all you need to do is adjust

the setting on the HOT LIMIT SAFETY STOP. "A"

TEMPERATURE SETTING NUMBERS

"B"

ADJUSTMENT WHEN WATER IS TOO COLD

PRY RED RING FORWARD AND ROTATE CLOCKWISE

"B"

4

5 6

ADJUSTMENT WHEN WATER IS TOO HOT

"A" PRY RED RING FORWARD AND ROTATE COUNTER-CLOCKWISE ONE CLICK

0

1

2

3

	1
"RED RING"- HOT LIMIT SAFETY STOP
4 SERVICE		1
If faucet drips, operate handle several times from "off"	4	2
to "on". Do not apply excessive force.
Clogged CARTRIDGE (4) inlets may cause reduced flow in "full		3
on" hot or cold. To clean inlets, first turn off water supply, then:
Remove HANDLE (1), CAP (2) and CARTRIDGE (4). Clean inlets and MANIFOLD (5).
Reassemble CARTRIDGE (4), alternately tightening SCREWS (3).	5
Replace CAP (2) and HANDLE (1). Check flow.

5 CARE INSTRUCTIONS:

DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.

DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.

M968805 REV. 1 . 4