American Standard 2064.4 POP-UP Drain, Remove Flange, Flange Gasket, POP-UP ROD Assembly

3 POP-UP DRAIN	Fig. A.		Fig. B.
Remove CLEAR PLASTIC COVER (1).		1
Remove CARDBOARD SPACER (2) from under			DRAIN
DRAIN POP-UP (3).		3	BODY
Tighten TAILPIECE (4) on DRAIN BODY before
installing DRAIN BODY. Fig. B.
	2		4

4 REMOVE FLANGE	Fig. A.		Fig. B.
Thread FLANGE (1) counter-clockwise and remove	1
FLANGE (1) and FOAM GASKET (2) from drain
body. Fig. A.
Thread LOCKNUT (3) clock-wise to bottom of
drain body. Push GASKET (4) down against
LOCKNUT (3). Fig. B.		2	4

3

5	INSTALL DRAIN FROM			6 TIGHTEN LOCKNUT
	BELOW FIXTURE
	From under side of BIDET			Tighten LOCKNUT (1) firmly with Adjustable
	install DRAIN BODY (1) up	4		Wrench or Channel Locks.
	through drain outlet.
	Note: No plumber’s putty	3
	or caulk is required.
	The CABLE ATTACHMENT		DRAIN
	POINT (2) must face towards		OUTLET
	the rear of the BIDET.		1			1
	Install FOAM GASKET (3) and
			2
	FLANGE (4) onto drain body
	from above BIDET and tighten
	FLANGE (4) firmly.
7 FLANGE GASKET			Fig. A.		Fig. B.	1
	Check DRAIN FLANGE in BIDET to ensure that WHITE					3
	FOAM GASKET (1) is fully compressed and not visible.
	Fig. A.		DRAIN
	POP-UP ROD ASSEMBLY		FLANGE
						SLOTTED
	Insert LIFT ROD GUIDE (1) and CABLE CONNECTOR (2)					MOUNTING
						NUT
	through rear hole, making sure SEAL WASHER (3) is					4
	properly seated. Fig. B.			1 WHITE FOAM
					ILLUSTRATION
				GASKET		2
	From below slip slot in MOUNTING NUT (4) over CABLE		(5).	NOT VISIBLE	SHOWN LESS
					VALVES
	Thread NUT (4) onto lift rod guide shank to secure ROD
	GUIDE (1) to bidet. Hand tighten only. Fig. B.					M968924 Rev.1.3