Frigidaire 2020252A0373, FRA123PT1 Installation Instructions, Exausting HOT AIR

Installation Instructions

Installation Instructions

EXAUSTING HOT AIR

In the COOLING Mode the appliance must be placed close to a window or opening so that the warm exhaust air can be ducted outside.

First position unit on a flat floor and make sure there’s a minimum of 12" clearance around the unit, and is within the vicinity of a single circuit outlet power source.

1.Take the hose out from back of the unit (Fig. 3).

2.Remove adaptor A from unit by sliding sideways (Fig. 4 ).

3.Extend either side of the hose (Fig. 5) and screw the hose to adaptor A (Fig. 6) .

4.Extend the other side of the hose and screw it to adaptor B (Fig. 7).

5.Slide the assembly onto unit (Fig. 8).

6.Affix the adaptor B into the window slider kit and seal. (Fig. 9&10)

Vertical

window

Window Slider Kit

Minimum:26.6"(67.5cm)

Maxmum:48.5"(123cm)

Fig. 9

Horizontal
window
Window Slider Kit
Minimum:26.6"(67.5cm)
Maxmum:48.5"(123cm)	Fig. 10

Take the hose out

Fig. 3

Slide out

Fig. 4

Extend the side of hose Fig. 5

Fig. 6

The hose can be extended from its original length of 15" up to 55", but it is the best to keep the length to minimum required. Also make sure that the hose does not have any sharp bends or sags. (Fig. 11)

Fig. 11

Fig. 7

Slide onto

Fig. 8

2009 Electrolux Home Products, Inc. All rights reserved. 5