Frigidaire FGHD2472PF installation instructions Installation in a double-hung sash window

Installation Instructions

Installation Instructions
(continued)
Installation in a double-hung sash window
1. Cut the foam seals(adhesive type) to the proper lengths and attach them
to the window and stool. (Fig. 10)	Foam seal A
2. Open the window sash and place the window slider kit on the window stool
	(adhesive type)
(Fig. 11). Attach the window slider kit to the window stool. Adjust the length
of the window slider kit according to the width of window. Screw down the
two screws on the window slider kit. See Fig.11. Cut the adjustable window	Fig. 10
slider kit if the width of window is less than 26.6 inches (Fig. 12).
3. Close the window sash securely against the window slider kit. (Fig. 13)	screws
4. Drive two 1/2" screws to secure the window slider kit to the window sash.
(FIG. 13)
5. Secure the window slider kit to the window stool (FIG. 13):	Window slider kit
A: For wooden windows: Use 3/4" screws for securing.
B: For Vinyl-Clad windows: Use ƎKH[KHDGFDSVFUHZV for securing.

6. To secure lower sash in place, attach right angle sash lock with		26.6"~48.5"
ƎPPVFUHZDVVKRZQ),*
		Window stool
NOTE: It is difficult to lock the windows with the sash lock for Vinyl-Clad			Fig. 11
windows, so you can use lock by window itself.
7. Cut the foam seal to an appropriate length and seal the open gap		Cut this side to fit your window
between the top window sash and outer window sash, as shown in Fig.15.
ļVFUHZV
Window slider kit	Fig. 14		Fig. 12
Foam seal	Fig. 15

ļVFUHZVRUļ
hex head cap screws	Fig. 13
Window stool
	Foam seal
	(adhesive type)
Installation in a sliding sash window

1.Cut the foam seals(adhesive type) to the proper lengths and attach them to the window frame. See Fig.16.

2.	Open the window sash and place the window slider kit on the window stool.		Fig. 16
	See Fig.17. Attach the window slider kit to the window stool. Adjust the
	length of the window slider kit according to the height of window. Screw	Window stool	Window slider kit
	down the two screws on the window slider kit. See Fig.17. Cut the adjustable
	window slider kit if the height of window is less than 26.6 inches (Fig. 12).		screws
3.	Close the sliding sash securely against the window slider kit. (Fig. 18)
4. Drive two 1/2" screws to secure the window slider kit to the window sash.
	(Fig. 18)	26.6"~48.5"
5.	Drive two 3/4" screws to secure the window slider kit to the window stool.
	(Fig. 18)

6. Cut the foam seal to an appropriate length and seal the open gap			Fig. 17
between the sliding sash and outer window sash, as shown in Fig.19.
7. To secure the sliding sash in place, attach right angle sash lock with 1/2"
	Window stool	Window slider kit
(12.7mm) screw as shown.(Fig.20)

Foam seal ļVFUHZV

ļVFUHZV

Fig. 19 Fig. 20 Fig. 18

2009 Electrolux Home Products, Inc. All rights reserved. 7