Frigidaire 220211A243 manual To USE the Energy Saver Feature, YOU will see, Sleep Feature

Air Conditioner Features

(continued)

TO USE THE ENERGY SAVER FEATURE:

DO THIS:

.

PRESS ENERGY

SAVER BUTTON

YOU WILL SEE:

LIGHT On

72

Note: In this mode, the fan will continue to run for 3 minutes after the compressor shuts off. The fan then cycles on for 2 . minutes at 10 minute intervals until the room temperature is above the set temperature, at which time the compressor turns

back on and cooling stars.

TIMER: DELAY STOP / START

FEATURE

YOU WILL SEE: TIMER SETTING

LIGHT On

0.5

.

DO THIS:

PRESS

TIMER BUTTON

THEN

DO THIS:

PRESS

TEMP/TIMER

BUTTON

8.5

Note: For Delay Stop, the unit must be in the On position.

Note: For Delay Start, the unit must be in the Off position.

To adjust timer setting, tap or hold the UP arrow(		) or the DOWN
arrow(	) to change delay timer at .5 hour increments, up to 10

.	hours, then at 1 hour increments up to 24 hours. The control will count
	down the time remaining until start (8, 7.5, 7, etc.). The Delay Start
	mode automatically selects cooling with maximum Fan Speed. The
	temperature maintained will be the same as previously set. To change
	the set temperature, press “COOL” then Up or Down arrows until the
	desired temperature is indicated on the display. After 5 seconds, the
	control will automatically change the display back to the hours re-
	maining until the unit will start/stop. Turning the unit “ON” or “OFF” at
	any time will cancel the Delay Start/Stop function.
	The Delay Start/Stop Feature will work until the unit either starts or
	stops. Once that happens the above steps have to be repeated again.

SLEEP FEATURE:

88

.

DO THIS:

PRESS

SLEEP BUTTON

YOU WILL SEE:

88

.

LIGHT On

Note: In this “MODE” the selected temperature will increase by 2 degrees F 30 minutes after the mode is selected. The temperature will then increase by another 2 degrees F after an additional 30 minutes. This new temperature will be maintained for 7 hours before it returns to the originally selected temperature. This ends the “Sleep” MODE and the unit will continue to operate as originally programmed. The “Sleep” MODE program can be cancelled at any time during operation by again pressing the “Sleep” button.

8