Mitsubishi Electronics MSH-07NV, MSH-12NV 2The reset button can be located on the front side

(2)<The reset button can be located on the front side.>

MSH-07NV - E1 MSH-12NV - E1 MSH-07NV - E2 MSH-12NV - E2 MSH-24NV - E2

(Serial number 7000201T~)	MSH-09NV	- E1
(Serial number 7000001T~)	MSH-24NV	- E1
	MSH-09NV - E2
	MSH-18NV	- E2
	MSH-18NV	- E3

(Serial number 7000201T~)

(Serial number 7000001T~)

How to modify the remote controller P.C. board

Remove batteries before modification.

The board has a print as shown below :

NOTE : For remodeling, take out the batteries at first.

After finish remodeling, put back the batteries then push the RESET button.

The P.C.board has the print “J1” and “J2”.Jumper wires are mounted to each “J1” and “J2”.Cut J1 and J2 according to the number of indoor unit as shown in Table 1.

After modification,push the reset button.

Table.1

	1 unit operation	2 units operation	3 units operation	4 units operation
No. 1 unit	No modification	Same as at left	Same as at left	Same as at left
No. 2 unit	–	Cut J1	Same as at left	Same as at left
No. 3 unit	–	–	Cut J2	Same as at left

No. 4 unit

–

–

–

Cut both J1 and J2

NOTE : At power supply failure or installation, indoor unit deletes the memory about remote controller. When the power supply is turned on and indoor unit receives the first signals from the remote controller, the remote controller number is designated as the indoor unit number. Therefore at and after the second time indoor unit accepts the remote controller of the initial setting number.

At setting - error, turn the power supply off to cancel the individual operation and then turn the power supply on to restart the setting.

45