Kompernass KH1025-05/08-V2 Commissioning, Boiling water, Cleaning and Care, Injury hazard

Page 5

Commissioning

Before taking the appliance into use, ensure that ...

- the appliance, plug and power cable are in good working order and...

– all packaging materials have been removed from the appliance.

Fill the appliance up to the MAX marking on the scale e with a water and vinegar mixture having a mix-ratio of 6:1 and then bring it to be boil – as described in the next section.

Warning

Do not inhale the vapours escaping during the boiling process! This could lead to irritation of the mucous membranes and an indisposition.

When the process is finished, pour the water- vinegar mixture away.

Rinse the kettle out with clear water.

Fill the appliance with water up to the MAX marking on the scale e and then bring it to be boil. When done, pour it away also.

at least to the MIN mark, so that the appliance does not overheat,

no higher than the MAX mark, so that no boiling water spills out.

First close the lid w...

and then place the kettle on the base t such that it is standing absolutely upright on the base t.

Now insert the power plug into the power socket ...

and press the ON/OFF switch r upwards until it engages.

The control lamps integrated into the ON/OFF switch r indicate that the appliance is now heating the water up.

The appliance switches itself off and the control lamps go out as soon as the water is on the boil. The ON/OFF switch r springs down.

Warning

Remove the plug from the wall socket before you lift the kettle from its base t. This prevents causing a potential short circuit by water possibly spilling out of the carafe and falling onto live electrical connec- tions in the base t.

Boiling water

Danger

Never place the electrical base t near water – life-threatening danger!

Lift the kettle off of the base when filling it!

Remove the lid w in that you pull it upwards.

Hold the kettle upright while filling it. Only in this way can you correctly read the markings on the scale e.

Fill the kettle ...

Injury hazard

For safety reasons, the lid w should not be opened while the water is boiling or is very hot. There is a risk of receiving severe scalds.

Cleaning and Care

Danger

Do not open any part of the housing. There are no user-servicable elements inside. An open housing can create the risk of a lethal electrical shock.

- 3 -

Image 5
Contents Retro Kettle Page Index Safety information Technical DataRetro Kettle KH Intended useCommissioning Cleaning and CareBoiling water Injury hazardDisposal StorageTake the lid w off Case of doubt, please contact your waste disposal centreWarranty Units Bilston Industrial Estate Oxford Street Warranty and Service ImporterYour goods be assured Intended for commercial use