Directed Electronics manual Specifications, Directed model 600/5 Ch 1-4Sub Ch, watts watts

SPECIFICATIONS

Directed model 600/5 Ch 1-4 Sub Ch.

RMS continuous power per channel, Channels 1-4 driven into 4 ohms from 20 to 20,000 Hz, with less than 0.08% total Harmonic Distortion @ 14.4 VDC. Sub channel driven into 4 ohms from 20-250 Hz, with less than 0.4% THD @ 14.4 VDC.

35150

watts watts

RMS continuous power per channel, Channels 1-4 driven into 2 ohms from 20 to 20,000 Hz, with less than 0.1% Total Harmonic Distortion @ 14.4 VDC. Sub channel driven into 2 ohms from 20-250 Hz, with less than 0.6% THD @ 14.4 VDC.

RMS continuous power, 3-channel operation, channels 1-4 bridged into 4 ohms from 20 to 20,000 Hz, with less than 0.1% Total Harmonic Distortion @ 14.4 VDC.

Dynamic power rating (IHF 202 standard) at minimum load

50250

watts watts

100x2 250

watts watts

600

watts

Signal-to-Noise Ratio		Greater than 95 dB (Ch 1-4),
		80dB (sub)
Frequency Response		20-20,000 Hz ± 0.5 dB
		(Ch 1-4)
Damping Factor @ 4 ohm		Greater than 100 (Ch 1-4),
		50 (sub)
Crossover (Ch 1-4)		Switchable high or low pass
		12 dB/octave, continuously
		variable 50 to 500 Hz
Subwoofer Crossover		Low pass 12 dB/octave,
		variable 30 to 250Hz
Bass Equalization		Switchable 8 dB
Input Impedance		20K ohms
Input Sensitivity		Variable from 150 mV to
		8 volt
Output Impedance	(ch 1-4)	2 to 8 ohms, stereo
		4 to 8 ohms, bridged
	(Sub ch.)	2 to 4 ohms
Supply Voltage		10 to 16 VDC
Fusing and Power		25A x 2
Minimum Cable Requirements (AWG)		#8
(Per amp, trunk mounted)

14 © 2003 Directed Electronics, Inc