Control Panel
•Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated.
Turn the hood on a few minutes before you start cooking.
The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The control switches are located on the hood’s front panel:
1 | 2 | 3a b | 4 | 5 | 6 |
Fig. 3
1- Mains switch, ON/OFF
Press for less than 1 1/2 seconds and the cooker hood goes into the "stand by" position (point "b" is illuminated).
Press for more than 1 1/2 seconds and the cooker hood turns off, ALL the controls (except the light push button) are disabled (the display is off).
Press again for more than 1 1/2 seconds to reset the cooker hood to "stand by".
2- Light ON/OFF
3 - Display
4- Start and choice of motor speed
5- Intensive speed on/off. The Intensive speed runs for 5 minutes:
If the hood is on when the Intensive speed is activated, the hood will revert to previous speed after 5 minutes.
If the hood is off when the Intensive speed is activated, the hood will automatically turn off after 5 minutes.
To interrupt the Intensive speed, press button 1 or 5.
The letter P appears on the display and the remaining time (the point “a” is flashing), if interrupted an acoustic signal is heard.
6-
The | 1st speed level 20 minutes |
| 2nd speed level 15 minutes |
| 3rd speed level 10 minutes |
The display shows the remaining operation time, at the end of the time an acoustic signal is heard. Depressing the
Should the hood or the controls fail to operate: disconnect the power supply for at least 5 seconds. After reconnecting the power supply wait 15 seconds and then check that the cooker hood is now operating
correctly.
66