Regular cleaning
It is recommended to wash the inside of the refrigerator in
Household cleaner or soap must not be used.
After breaking the circuit wash the appliance with lukewarm water then wipe it. Clean the door gasket with clean water. After cleaning apply voltage to the appliance.
It is recommended to remove the dust and dirt collected on the back of the refrigerator and the condenser and to clean the evaporative tray on top of the compressor once or twice a year.
When the refrigerator is not in use
In case the appliance will not be used for a long time follow these steps:
Break the circuit of the appliance.
Remove foods from the refrigerator.
Clean it as written before.
Leave the door open to avoid a build up of air inside.
GB electrolux 43
Trouble shooting
How to change the bulb
Should the light fail to work you can change it as below: Break the circuit of the appliance. Press the rear hook (1) and at the same time slide the cover
in the direction indicated by the arrow (2). So the bulb can be replaced. (Bulb type: T 25
thread) After changing the bulb replace the cover, snap it in place and apply voltage to the appliance.
If something does not work
During operation of the appliance some smaller but annoying trouble can often occur, which does not require calling a technician out. In the following chart information is given about them to avoid unnecessary charges on service.
We draw your attention that operation of appliance goes with certain sounds (compressor- and circulating sound). This is not trouble, but means normal operation.
We draw it to your attention again 
that the appliance operates discontinuously, so the stopping of compressor does not mean being no-
current. That is why you must not touch the electrical parts of the appliance before breaking the circuit.