Electrolux EFP 60241 manual Installation, Drilling the Support surface and Fitting the Hood

INSTALLATION

Drilling the Support surface and Fitting the Hood

•	The Hood can be fitted directly on the
	lower surface of the Wall Units (650 mm
	min. above the Cooker Top) using the snap-
	on Side Supports.
•	Make an opening on the lower surface of

1

2

	the Wall Unit, as indicated. (fig.1)
• Before carrying out the installation, the
	wooden transportation protections screwed
	on the visor and on the canopy body must
	be removed. (fig.2)
•	Choose the correct flange measure basing
	on the air outlet diameter and insert it to the
	upper air outlet opening. (fig.3)
•	Screw the closing profile 20 onto the rear
	part of the hood, using the screws 12f (2.9
	x 9.5) provided. (fig.4)
• Open the sliding suction panel.
•	Remove the metal grease filters one by one
	after having disconnected the relative fas-
	tening elements.
• Close the sliding suction panel again.
•	Insert the Hood until the snap-on side sup-
	ports click into place. (fig.5)
• Open the sliding suction panel.
•	Lock in position by tightening the screws
	Vf from underneath the Hood. (fig.5)
•	If necessary, adjust the whole filter holder
	unit and proceed as follows:
	•	Loosen the four adjustment screws Vr
		and close the sliding panel again. (fig.6)
	• Move the entire filter holder unit until it
		is properly aligned with the wall unit.
		(fig.7)
	•	Keeping the hood canopy still, remove
		the sliding panel and lock the adjustment
		screws again. (fig.6)
	•	The hood can now be fastened to the
		wall unit using the four screws 12a (3.5
		x 16) provided. (fig.8)
• Replace the metal grease filters.
• Close the sliding suction panel again.

162

523

10b

10a

9

10a

3

4

5

Vr

6

7

12a

8

EN	8
	8