Special accessories
Active carbon filter
When the hood is used in recirculation mode an active carbon filter should be used.
Order by the retailer
PNC 955 101 117
Installation
Unpacking
Check that the cooker hood has no damages. Transportation damages should immediately be reported to the one responsible for the transport Damages, faults and eventually missing details should immediately be reported to the seller.
Take care of the packing material so that smallFig. 3 children cannot play with it.
Min | Min | |
75 cm | ||
65 cm |
Placement
The hood is to be mounted in a wall cupboard. When installed, the hood must be not less than 65 cm. above electric burners or 75 cm. above gas or
Electrical connection
The hood has a power cord with moulded plug with earth connection to be connected to a wall outlet of 230 V.
The power cord length is 1,25 m.
Mounting under wall cabinet
●Drill holes on the bottom of the cupboard as shown in the supplied drilling diagram (Fig. 4), do not consider the thickness of the front panel of the cupboard.
●From inside the cupboard, insert the four 4.2x35 screws C (Fig.5) supplied with the unit and screw them onto nuts F (Fig.5).
●By means of the appropriate screws, fit the angle iron E (Fig.6) so that it is tightly fixed to the wall.
●Make an hole on the top of the cupboard for the passage of the discharge (see the drilling diagram for diameter).
Fig. 4
C C
F F
Fig. 5
Fig. 6
CC
FF
E
5