INSTALLATION
Location
The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc.
Electrical connection
Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage.
electrolux 35
Door reversibility
The appliance’s door have been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom.
Instructions for totally built-in appliances
For operation with different voltages, a suitably sized
The appliance must be earthed.
The power supply cable plug is provided with a contact for this purpose.
If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician.
The Manufacturer declines all responsibility if the above safety precautions are not observed.
This appliance complies with the following E.E.C. Directives:
-87/308 EEC of 2/6/87 relative to radio interference suppression.
-73/23 EEC of 19.2.73 (Low Voltage
Directive) and subsequent modifications;
-89/336 EEC of 3.5.89
(Electromagnetic Compatibility
Directive) and subsequent modifications.
ATTENTION!
It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation.
Building-in instructions
50 mm | min. |
200 cm2 | |
| min. |
| 200cm2 |
D567 |
|
For safety reasons, minimum ventilation must be as shown in Fig.
Attention: keep ventilation openings clear of obstruction.
It is necessary that the niche is provided with a ventilation conduct having the following dimensions:
Depth | 50 mm |
Width | 540 mm |
Dimensioned drawings
See „ Installation Instructions“ supplied.