Freezer compartment
¥Remove the frost with a plastic scraper.
¥Whenever the thickness of the frost exceeds 5 mm complete defrosting should be carried out. Prooceed as follows:
¥Remove any stored food, wrap it in several layers of newspaper and put it in a cool place.
¥Pull out the plug from the wall socket or turn the thermostat knob to the ÇOÈ setting.
¥Leave the door open, place a basin on the top shelf of the refrigerator compartment, under the drain hole, remove the plug as shown in the figure.
PR151 |
¥When defrosting is completed, dry the interior thoroughly and refit the plug.
¥Turn the thermostat knob back to the required setting or replace the plug in the power socket.
¥Reload the previously removed food into the compartment.
Never use sharp metal tools to scrape off frost from the evaporator as you could damage it.
Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer.
Cleaning
Never use metal objects for cleaning your appliance as it may get damaged.
NEVER use detergents, abrasive powders, highly perfumed cleaning products or wax polishes to clean the interior as these will damage the surface and leave a strong odour.
Clean the inside with warm water and bicarbonate of soda. Rinse and dry thoroughly.
The appliance is equipped with a ventilation grid. Keep clean to guarantee good ventilation and good working order of the appliance.
An accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption.
The structure of the appliance permits cleaning of the rear zone close to the wall, using a vacuum cleaner.
1. Remove the plinth (1), then the ventilation grid (2);
3 | 2 | 1 |
S.I.013 |
|
|
2.Carefully pull the air deflector out (3), checking that there is no water left from the defrosting.
When the appliance is not in use
Disconnect the appliance from the electricity supply. Empty all foods and clean the appliance, leaving the doors ajar to prevent unpleasant smells.
Changing the light bulb
¥Should the interior light fail to work, first switch off the appliance and disconnect from the electricity supply, then replace the bulb as follows:
1.unscrew the light cover securing screws.
2.unhook the moving part by pressing it as shown in the figure.
3.Replace the bulb by other with another with the same charcteristics.
D411 |
19