Electrolux EFA9620 user manual Use electrolux

Use electrolux 13

Touch	Basic functions			Indicator lights
control	Dual Function
L	When briefl y pressed it switches the lighting			Touch control		Lights off
	system on and off.			unlit
	When pressed for 2 seconds it starts the			Touch control lit		Lights on
	lighting system in “courtesy light” mode.						EN
	The lamps are fed at a reduced power of
	approximately 5W. Such function can be
				Touch control		Courtesy light on
	stopped by pressing the touch control for 2
				unlit
	seconds or just by pressing it shortly in order to
	return to the normal lighting mode. In courtesy
	light mode the touch control is not lit.
T1	When pressed the motor is stopped, regardless			Touch control lit		Motor on
	of the speed it is set to.			Touch control		Motor off
				unlit
T2	When pressed the motor is set to the fi rst speed				Touch control lit
T3	By a brief pressing the motor is set to the second			Touch control lit		Second speed on
	speed.
	By pressing the touch control for approximately			Flashing touch		Delay function on
	2 seconds the Delay function is enabled, i.e			control
	delayed shutdown of the appliance ensuring
	a complete elimination of the residual odours.
	This function can be activated at OFF-position
	and at 1°, 2° and 3°speeds. It can be stopped
	in advance by pressing any of the touch
	controls (T) with the exception of T3. The Delay
	function works according to the following
	scheme:
	1°speed / OFF	=	20 minuets
	2°speed	=	15 minutes
	3°speed	=	5 minutes
T4	When pressed the motor is set to the third speed				Touch control lit
T5	When pressed the motor is set to the intensive
	speed timed to 5 minutes. At the end of 5
	minutes of intensive speed the hood starts again
	at the speed it was set to previously. In case the				Touch control lit
	hood is set to the intensive speed directly from
	OFF-state it will then start from the fi rst speed
	after 5 minutes of intensive speed.
F	When pressed for 4 seconds it resets the fi lter			Touch control lit		Metal grease fi lters saturation
	alarm signal indicated by fl ashing of the touch					alarm. Metal grease fi lters need
	control T1. This procedure can be carried out					to be washed. The alarm starts
	only when the motor is stopped.					up after 100 working hours.
				Flashing touch		Charcoal fi lter saturation
				control		alarm. Charcoal fi lter has to
						be replaced and metal grease
						fi lters washed. The alarm
						starts up after 200 working
						hours. (Activation; check the
						paragraph “Charcoal fi lter”)