Electrolux 727023, RH14RE4HU, RH14RE2FEU, RH14DFD2FU manual 2POSITIONING, Reversing Opening of Doors

pressed board: protective surround elements

B.1.2POSITIONING

Install the equipment, taking all the safety precau- tions required for this type of operation, also respecting the relevant fire-prevention instruc- tions.

Place the appliance in a ventilated room and away from heat sources such as radiators or air-condi- tioning systems, in order to allow the cooling of the refrigerating unit components.

Never cover the condenser, not even temporarily, as this may jeopardise the operation of both the condenser and the appliance.

Make sure to position the appliance taking into consideration the space needed for door opening.

Pay particular attention to levelling of the floor on which the appliance stands, in order to ensure its optimal operation.

IMPORTANT:

level the appliance, otherwise its operation could be compro- mised.

Use the height-adjustable feet to make sure the appliance is level, and at the same time check that the door closes properly.

B.1.3 REVERSING OPENING OF DOORS (Fig.5)

Single-door refrigerated cupboards are normally supplied with right opening.

When changing to left opening, proceed as follows:

•disconnect from the power supply;

•open the control panel, loosening the 2 screws located be-

tween the panel and the door;

•undo the 2 screws fixing bracket “A” and the screw fixing hinge “B” (Detail 1);

•remove the door, the hinge “B” and the component “E”, then reverse their assembly;

•remove the lower bracket “D”, refitting it in the special seat on the opposite side (Detail 2);

•position the door on the lower bracket “D”;

•position the upper bracket “A” between the door and the top of the equipment, screwing the fixing bolts;

•before tightening the screws, align the door with respect to the side of the unit, operating the lower and upper brackets and checking correct fitting of the seal on all sides of the unit;

•then tighten the bracket fixing bolts;

•reconnect the power supply.

For trouble-free operation of the appliance, it is recommended that a gap of at least 19.68”/ 500mm be left between the appli- ance and the ceiling.

Should the appliance be installed in rooms where there are corrosive substances (chlorine, etc.), it is advisable to go over all the stainless steel surfaces with a cloth coated with vaseline oil, in order to form a protective film.

The maximum ambient temperature at which the appliances may operate is +109.4°F/+43°C.

19.68 " 500 mm

2550100 mm.39"

7 28.
30 74"
mm
Note: the power plug should be accessible even after having
placed the appliance in its final position for installation.	42

B.1.4 REVERSING OPENING OF HALF DOORS (Fig.6) Single-door refrigerated cupboards are normally supplied with right opening.

When changing to left opening, proceed as follows:

•disconnect the power supply;

•open the control panel, loosening the 2 screws located be- tween the panel and door;

•undo the 2 fixing screws of bracket "A" and the fixing screw of hinge "B";

•remove the door;

•remove the middle bracket "F" and remove the bottom door;

•remove the lower bracket "A" refitting it on the opposite side in the special seat;

•position the bottom door on the lower bracket "A";

•fix the middle bracket "F";

•position the top door on the middle bracket "F";

•fix the upper bracket "A" between the door and the roof of the unit, screwing the fixing bolts;

•before tightening the screws, align the door with the side of the cabinet by moving the lower and upper brackets, checking correct fitting of the seal on all sides of the cabinet;

•then tighten the bracket fixing bolts.