Electrolux 50750 i manual Work surface must be re-mounted

Page 32

Installation and Connection Instructions

•If the dishwasher is installed under- neath a kitchen work surface, the original work surface of the dish- washer is to be removed as follows:

–Unscrew the screws (1) from the elbows on the back side.

–Slide the work surface approx. 1cm to the rear (3) , lift at the front (4) and remove.

–Press the work surface retaining brackets at the position shown in the diagram (4) and remove the bracket at an angle to the rear

(5).

4

5

1	If the dishwasher is later used as a free-standing appliance, the original
	work surface must be re-mounted.
3	The plinth on free-standing appliances is not adjustable.

32

Image 32

Contents Ökofavorit 50750 Tips on using the appliance Dear customerPlease read these user instructions carefully Pass them on to any subsequent owner of the applianceContents Installation and Connection Instructions Safety Instructions Installation, Connection and Placing into OperationChild Safety General SafetyCorrect Use Disposal Economical and Ecological DishwashingDisposing of the Packaging Material Disposal of Old AppliancesAppliance Features and Control Panel Prior to using for the first time Control panelHardness range of the water in your area Adjust the Water SoftenerSalt Filling with Salt for the Water Softener Fill with saltUse salt Open the door, remove the lower rackFilling with Rinse Aid Ough rinsing, spot and streak free dryingAge the appliance Fill with rinse aidReplace the lid and tighten by turn- ing clockwise Adjusting Rinse Aid DosingDaily Use Loading Cutlery and Dishes Loading Cutlery Loading Pans, Frying Pans and Large Plates Load large and heavily soiled dishes in the lower rackLoading Cups, Glasses Coffee Services Adjusting the Height of the Upper Rack Lowering the Upper RackRaising the Upper Rack Pull out the upper rack to the stopFilling with Detergent Use only dishwasher detergentFill with Detergent Tions given on the detergent packagingBio Wash Programmes and Concentrated Detergents Detergent recommendationsSelecting the Wash Programme Programme Table SoilingChanging/Interrupting/Cancelling Start the Wash ProgrammeWash Programme Changing the wash programmeSetting or Changing the Delay Start Timer Cancelling the wash programmeDishwasher is switched on again Changing the delay startEmptying the Dishwasher Care and CleaningSwitching Off the Dishwasher Cleaning the Filter Error messages What to do, ifThere are problems with the operation of the dish- washer Wash results are not satisfactoryDishes are still dirty Dishes are wet and dullThere are dried water drops on the glasses and dishes Technical DataLower rinse aid dosing Example Loading Arrangement Upper rack Bottom rack with cutlery basketInstalling the Dishwasher An open-end spanner ScrewdriverFree-Standing Appliances Dishwashers That Can Be IntegratedBuilt-In Dishwasher Plinth on free-standing appliances is not adjustable Work surface must be re-mountedConnecting the Dishwasher Water ConnectionPermitted water pressure Connect the inlet hoseWater drain Drain hoseExtension hoses Sink outlet connectionLeak Prevention System Appliance is automatically pumped outElectrical Connection Changing a fuseConnections Guarantee Conditions Calls may be recorded for training purposes 08705 929Customer Care