If the refrigerator is not cooling sufficiently, the reason may be:
1.Inadequate ventilation of the cooling unit due to the intake and/or exhaust air vents being partly or completely blocked.
2.The evaporator is frosted up.
3.The thermostat setting is incorrect .
4.Gas pressure is incorrect - please check the pressure regulator on the gas container.
5.The ambient temperature is too high.
6.Too much food is loaded at one time.
7.The door is not properly closed or the magnetic sealing strip is defective.
If the refrigerator still does not work properly, call a service technician.
WARNING! The sealed cooling system must not be opened, since it contains corroding chemi- cals under high pressure.
MAINTENANCE
Always turn to a qualified service technician who is familiar with LP gas systems and refrigerator.
We recommend that a service technician check the refrigerator once a year.
•Check all connections in the LP gas system for gas leaks. Connections can be tested for leaks using a soap solution. Do not use a naked flame! If there is any suspicion of damage, call for a service technician.
•The ventilation openings are unobstructed.
•The Instruction Manual is available.
•Check that the burner is clean and free from combus- tible material.
SOME USEFUL HINTS
Make sure that:
•The refrigerator is not operating on 12 V when the vehicle is parked; otherwise you will drain the car battery in a short time.
•Defrosting is carried out periodically
•The refrigerator is clean and dry with the door left open when it is not to be used for some time.
•Liquids or items with a strong odour are well packed.
•The ventilation openings are unobstructed.
•The doors are secured by means of the both travel catches when the caravan is on the move.
SERVICE AND SPARE PARTS
Service and spare parts are obtainable from your dealer or Electrolux - consult the telephone directory.
INSTALLATION INSTRUCTIONS
REPOSITIONING THE HINGES
The refrigerator is equipped with reversible doors.
A special door reversing kit must be used to reverse the doors.
For further information, contact your dealer or Electrolux.
DOOR PANEL
Door panels can easily be fitted or changed. The dimen- sions of the panels must be:
Model
Height upper door lower door
Width Thickness max.
Before starting the mounting work, check that the panel dimensions are in compliance with those given in the table and the instructions are read thoroughly.
When mounting the panel, proceed as follows:
Upper door
•remove the two screws holding the control panel, pull out the two knobs (energy selector and thermostat)
•unscrew the upper hinge pin and remove the door
•unscrew the upper part of the door frame, remove the old panel
•insert the new panel and push the panel downwards
•fasten the upper part of the door frame with its three screws
•please note that the panel must be changed on the lower door, before the upper door can be mounted
lower door
•unscrew the middle hinge pin and remove the door
•unscrew the lower part of the door frame, remove the panel stop (2x) and remove the old panel
•insert the new panel and push the panel upwards, put the panel stop back in place and fasten the lower part of the door frame with its three screws
•replace the lower door
•replace the upper door
•replace the control panel with its two screws and put on the knobs.
14