Malfunction | Possible cause | Remedy | |
|
|
| |
|
|
| |
|
| seal with a | |
|
| dryer at those points which | |
Large accumulation of |
| are not airtight (no warmer | |
frost in the appliance, | Door is not properly sealed | than approx. 50°C). At the | |
perhaps also at the door |
| same time, shape the war- | |
seal. |
| med door seal by hand, so | |
|
| that it is again properly | |
|
| seated. | |
| Appliance is not level. | Readjust the front levelling | |
|
| feet. | |
| Appliance is in contact | Push appliance away a | |
Unusual noises. | with wall or other objects. | short distance. | |
|
| ||
| A part at the back of the |
| |
| appliance, e.g. a tube, is in | Please contact your Local | |
| contact with another | Service Force Centre | |
| appliance part or the wall. |
| |
The compressor does not |
|
| |
start immediately after | This is normal, no error has | The compressor starts after | |
changing the temperature | occurred. | ||
a period of time. | |||
setting. | Carefully warm the door | ||
| |||
|
|
|
Changing the Light Bulb
Warning! Danger of electrical shock! Before replacing the light bulb switch appliance off and remove the mains plug, or switch off or turn out the circuit breaker or fuse.
Light bulb specifications:
To switch the appliance off turn the temperature regulator to position "0".
Unplug the mains plug.
To change the light bulb, pull out the screw “Y” and then remove the protective cover “X”.
Change the defective light bulb.
Refit the light bulb cover.
18