Electrolux ZGS 782 ICT manual Operation, Lighting Burners, For easier, Pan on the pan support

Operation

Hob burners control knobs

The symbols on the knobs mean that :

there is no gas supply

there is maximum gas supply

	there is minimum gas supply
Lighting		the	burners
	For easier		lighting,		proceed before putting
)z	a pan on the pan support.
	To light a burner:
	turn the relevant knob anti-clockwise to maximum
	position (		), then push it down to ignite the
	burner.					Triple crown burner
z	Upon ignition, keep the knob pushed down
	about 5 seconds. This will allow the
	"thermocouple" (see diagram - letter D) to be					A
	heated and the safety device to be switched
	off, otherwise			the	gas supply would be	B
	interrupted.
z	Then adjust the flame as required.					D
	If the burner does not ignite, turn the control knob
						C
	to zero, and try again.
	If you cannot light the flame even after					A - Burner cap
	severalattempts, check the "cap" (see diagram					B - Burner crown
	- letter A) and the"crown" (see diagram - letter					C - Ignition electrode
	B) are in the correct position.					D - Thermocouple

8