Electrolux U26227 manual Installation, Building

Page 11

Installation

The hob must be installed according to the instructions supplied.

The hob must be installed by qualified personnel to the relevant British Standards.

Please, ensure that, once the hob is installed, it is easily accessible for the engineer in the event of a breakdown.

WHEN THE HOB IS FIRST INSTALLED

Once the hob has been installed, it is important to remove any protective materials, which were put on in the factory.

The manufacturer will not accept liability, should the above instructions or any of the other safety instructions incorporated in this book be ignored.

Cut Out Size

The dimensions of the cut-out are given in the diagram.

Supply Connections

This hob is designed to be connected to 230-240 V (50 Hz) electricity supply.

The cable used to connect the hob to the electrical supply must be 6mm, PVC twin and earth, and fused to 30amp.

It is necessary that you install a double pole switch between the hob and the electricity supply (mains), with a minimum gap of 3mm between the switch contacts and of a type suitable for the required load in compliance with the current rules.

The switch must not break the yellow and green earth cable at any point.

Building In

Building over a cupboard or drawer

If the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface.

It is also recommended to carry out the electrical connection to the hob as shown in diagrams 1 and 2.

Rectangular cut-out size for hob

500

580

 

470

550

FO 2225

 

1

ON/OFF SWITCH

 

FLEX

 

OUTLET

 

FO 0763

 

2

ON/OFF SWITCH

 

 

FLEX

 

OUTLET

FO 0764

 

 

1 1

Image 11
Contents Instruction Booklet Page Important Safety Information Description of the Hob ContentsElectric Hotplates Control Light OperationHints and Tips Electric HotplatesHotplates Maintenance and CleaningHob Top Something Not Working? Symptom SolutionStandard Guarantee Conditions Guarantee ConditionsEuropean Guarantee Location Instructions for the InstallerCut out dimensions Important safety requirementsBuilding InstallationFitting the Hob into the worktop Building over a kitchen unit with doorElectrical connections Supply Cable SpecificationsWiring diagram Page 02/07